3 Racing Sakura XI Sport
#1051
Tech Initiate
I run the xi sport in 17.5 blinky, and USGT. My cars are completely stock, and contenders every week. The diffs can be frustrating, but build according to the thread on here and they are fine. I run them out of the box, with spur gear changes. I have broken 1 right a arm in 13 races. Im even running the kit diff fluid, and with the spool in front I out corner and accelerate all of the other cars with dual diffs. Run the XI with confidence, great car.
My idea behind this TC is to build something below budget and show the guys you don't really need the most expensive chassis with top dollar Electronics to be competitive.
My Setup will be as follows.
Chassis: XI Sport
Body: 3 Racing Touring Car Body V.2
ESC : HW Justock XR10
Motor : Trinity D4 17.5T(45 Degree Timing)
Servo : Savox 1251MG Low Profile
Spur : 3 Racing 70T(48p)
Pinion: 3 Racing 32T(48p)
Battery : Trinity Nano-Tech 6500mah 65c-110c
Receiver & Radio : SR300 & Spektrum DX3C
Chassis Upgrades
- Aluminum Floating Servo Mount
- Universal Shaft Cushions 3.5mm
- Front 38T Gear Diff
- Front & Rear Stabilizer's
* These upgrades will be added before my first run *
Spares
- Front & Rear susp Arms(Graphite)
- Front & Rear Shock Tower(Normal)
- Steel Linkage Set & Ball End Set
- Front & Rear Low Friction Belts
- 70T(48p) Spur
- 30T & 34 T Pinion(48p)
- Rear Hubs(2dg)
- Knuckles
- King Pin Post
- C Hubs(4dg)
I'll be running the front diff on 500k oil & rear diff 2k oil.
If there is any advice please feel free to share... I'll be building my kit with the help of 3Racing's Facebook page that gives advice & tips on building the XI Sport.
Cheers
#1052
I have my most current baseline setup on page 63.
I would stay away from the graphite arms and also get a smaller spur gear. But YMMV.
Let us know how it goes!
I would stay away from the graphite arms and also get a smaller spur gear. But YMMV.
Let us know how it goes!
#1053
I can't wait to get this kit going. At my club the Top Guns run Xray T4, Yokomo BD7, TA 6.2, Durango DETC410 plus 1 Mi.5. - 17.5T Blinky
My idea behind this TC is to build something below budget and show the guys you don't really need the most expensive chassis with top dollar Electronics to be competitive.
My Setup will be as follows.
Chassis: XI Sport
Body: 3 Racing Touring Car Body V.2
ESC : HW Justock XR10
Motor : Trinity D4 17.5T(45 Degree Timing)
Servo : Savox 1251MG Low Profile
Spur : 3 Racing 70T(48p)
Pinion: 3 Racing 32T(48p)
Battery : Trinity Nano-Tech 6500mah 65c-110c
Receiver & Radio : SR300 & Spektrum DX3C
Chassis Upgrades
- Aluminum Floating Servo Mount
- Universal Shaft Cushions 3.5mm
- Front 38T Gear Diff
- Front & Rear Stabilizer's
* These upgrades will be added before my first run *
Spares
- Front & Rear susp Arms(Graphite)
- Front & Rear Shock Tower(Normal)
- Steel Linkage Set & Ball End Set
- Front & Rear Low Friction Belts
- 70T(48p) Spur
- 30T & 34 T Pinion(48p)
- Rear Hubs(2dg)
- Knuckles
- King Pin Post
- C Hubs(4dg)
I'll be running the front diff on 500k oil & rear diff 2k oil.
If there is any advice please feel free to share... I'll be building my kit with the help of 3Racing's Facebook page that gives advice & tips on building the XI Sport.
Cheers
My idea behind this TC is to build something below budget and show the guys you don't really need the most expensive chassis with top dollar Electronics to be competitive.
My Setup will be as follows.
Chassis: XI Sport
Body: 3 Racing Touring Car Body V.2
ESC : HW Justock XR10
Motor : Trinity D4 17.5T(45 Degree Timing)
Servo : Savox 1251MG Low Profile
Spur : 3 Racing 70T(48p)
Pinion: 3 Racing 32T(48p)
Battery : Trinity Nano-Tech 6500mah 65c-110c
Receiver & Radio : SR300 & Spektrum DX3C
Chassis Upgrades
- Aluminum Floating Servo Mount
- Universal Shaft Cushions 3.5mm
- Front 38T Gear Diff
- Front & Rear Stabilizer's
* These upgrades will be added before my first run *
Spares
- Front & Rear susp Arms(Graphite)
- Front & Rear Shock Tower(Normal)
- Steel Linkage Set & Ball End Set
- Front & Rear Low Friction Belts
- 70T(48p) Spur
- 30T & 34 T Pinion(48p)
- Rear Hubs(2dg)
- Knuckles
- King Pin Post
- C Hubs(4dg)
I'll be running the front diff on 500k oil & rear diff 2k oil.
If there is any advice please feel free to share... I'll be building my kit with the help of 3Racing's Facebook page that gives advice & tips on building the XI Sport.
Cheers
Dualsky xj550
Dualsky 17.5
Highest ds400 servo
Proline R9 body
#1054
Tech Addict
Had a another run on a small indoor carpet track. Its mostly for 1:12 Supastox Cars. Had my 2nd time there ever and I think the car is AWESOME! I had some pretty pretty serious bangs and nothing broke. It seems like a tank for me!
Car is very easy to handle, does nothing stupid. I think its one of the best cars for any beginner.
Did a small video:
https://youtu.be/wXZ58zPf7nM
Best guys run 07:10, my best was 08:40..so quite okay for me!
Car is very easy to handle, does nothing stupid. I think its one of the best cars for any beginner.
Did a small video:
https://youtu.be/wXZ58zPf7nM
Best guys run 07:10, my best was 08:40..so quite okay for me!
Last edited by man1ac; 04-29-2016 at 09:21 AM.
#1055
Tech Initiate
Hi Guys
I need help in choosing a lipo battery for my 17.5 Blinky Xi Sport.
I know the total weight of the servo&motor&esc incl wires will be around 295g.
Should I go for a big lipo with high MAH and C rating, or go with low MAH 3800 - 5000 low c rating but weight at around 280g? to make my balancing on the car easy to tune..?
I need help in choosing a lipo battery for my 17.5 Blinky Xi Sport.
I know the total weight of the servo&motor&esc incl wires will be around 295g.
Should I go for a big lipo with high MAH and C rating, or go with low MAH 3800 - 5000 low c rating but weight at around 280g? to make my balancing on the car easy to tune..?
#1056
Tech Initiate
Had a another run on a small indoor carpet track. Its mostly for 1:12 Supastox Cars. Had my 2nd time there ever and I think the car is AWESOME! I had some pretty pretty serious bangs and nothing broke. It seems like a tank for me!
Best guys run 07:10, my best was 08:40..so quite okay for me!
Best guys run 07:10, my best was 08:40..so quite okay for me!
#1057
Tech Regular
iTrader: (7)
I'm not sure where I went wrong...
I'm running my XI Sport box stock except for the springs. I have 5.5 coils in the front and 5.25 coils in the back. Even on foam tires, the car almost feels like it's on drift tires. It spins the tires on acceleration, slides under braking, understeers entering a turn, and oversteers on turn exit with anything more than a touch of throttle. I thought it was the foams, but swapping them onto another car worked fine...
What in the world have I done wrong??
I'm running my XI Sport box stock except for the springs. I have 5.5 coils in the front and 5.25 coils in the back. Even on foam tires, the car almost feels like it's on drift tires. It spins the tires on acceleration, slides under braking, understeers entering a turn, and oversteers on turn exit with anything more than a touch of throttle. I thought it was the foams, but swapping them onto another car worked fine...
What in the world have I done wrong??
#1058
I'm not sure where I went wrong...
I'm running my XI Sport box stock except for the springs. I have 5.5 coils in the front and 5.25 coils in the back. Even on foam tires, the car almost feels like it's on drift tires. It spins the tires on acceleration, slides under braking, understeers entering a turn, and oversteers on turn exit with anything more than a touch of throttle. I thought it was the foams, but swapping them onto another car worked fine...
What in the world have I done wrong??
I'm running my XI Sport box stock except for the springs. I have 5.5 coils in the front and 5.25 coils in the back. Even on foam tires, the car almost feels like it's on drift tires. It spins the tires on acceleration, slides under braking, understeers entering a turn, and oversteers on turn exit with anything more than a touch of throttle. I thought it was the foams, but swapping them onto another car worked fine...
What in the world have I done wrong??
- front swaybar
- traction compound in rear
- softer rear spring
- firmer front spring
- lean your rear shocks inward
What surface are you running on?
#1059
Hi Guys
I need help in choosing a lipo battery for my 17.5 Blinky Xi Sport.
I know the total weight of the servo&motor&esc incl wires will be around 295g.
Should I go for a big lipo with high MAH and C rating, or go with low MAH 3800 - 5000 low c rating but weight at around 280g? to make my balancing on the car easy to tune..?
I need help in choosing a lipo battery for my 17.5 Blinky Xi Sport.
I know the total weight of the servo&motor&esc incl wires will be around 295g.
Should I go for a big lipo with high MAH and C rating, or go with low MAH 3800 - 5000 low c rating but weight at around 280g? to make my balancing on the car easy to tune..?
#1060
Tech Initiate
#1061
Tech Adept
#1062
Weight is just one factor in balancing/setting a car. Positioning is another, as is spring pre-load.
Balance your car with a setup station and tweek board with the current battery you are racing with. From there, you'll have a better idea of what to do.
Balance your car with a setup station and tweek board with the current battery you are racing with. From there, you'll have a better idea of what to do.
#1063
Ok, seriously thinking about picking up this kit to start a VTA build. Have a small list put together of "preferred" inital upgrades. This will be my first touring style car and am stoked. Other than the kit/motor/esc/transmitter/servo/battery, here is what I have as preferred initial inverstments.
-Aluminum bulkheads
-Floating servo mount
-CVD- SAK-X27
-Yeah Racing X 3Racing Sakura XI Sport Performance Upgrade Combo Set #SAKXISCOMBO (gives me the upgraded hubs, arms, shocks, etc)
Any other MUST haves when getting this kit started for VTA?
-Aluminum bulkheads
-Floating servo mount
-CVD- SAK-X27
-Yeah Racing X 3Racing Sakura XI Sport Performance Upgrade Combo Set #SAKXISCOMBO (gives me the upgraded hubs, arms, shocks, etc)
Any other MUST haves when getting this kit started for VTA?
#1064
I'd pass on the yeah racing set and just got mure composite knuckles and hubs.
Or 4' xray hubs.
Or 4' xray hubs.
#1065
Tech Adept
You can buy an used xray for the money you want to spend
Or a Sakura Ultimate which has all the upgrades + many more.
The YR upgrade kit is pretty much useless for racing. I have never seen someone race with aluminum arms. And the shocks will not even fit the standard shock towers, only the carbon ones that are lower. Plus they are cca the same quality than the stock ones anyway.
Or a Sakura Ultimate which has all the upgrades + many more.
The YR upgrade kit is pretty much useless for racing. I have never seen someone race with aluminum arms. And the shocks will not even fit the standard shock towers, only the carbon ones that are lower. Plus they are cca the same quality than the stock ones anyway.