Tamiya TA05 Touring Sedan
#9871
Generally the spool will lose you off power steering on corner entry, especially if you're changing from a diff or one-way. i managed to get most of it back with a few setup changes though.
#9872
#9873
Went to a softer front spring and laid the front shocks down to the 2nd hole from last, added around a half degree of additional toe out in front but be careful with this it can make the car feel quite twitchy. Also added 1mm of rear droop to get more weight transfer to the front when coming off power.
#9874
Which hole do you guys attach the camber links? And the spacers? No one seems to tweak the roll centre and camber gain much?
#9875
Tech Elite
iTrader: (1)
Join Date: Mar 2007
Location: Bristol, England, United Kingdom
Posts: 4,857
Trader Rating: 1 (100%+)
#9876
Tech Initiate
Suspension Arms
Hi just want to ask about the above mentioned part of TA-05R
In my manual the part # is 51104
But the only part available in our LHS is design for TA-05ifs with part # 51297
Can i used the ifs part for my TA-05r? (w/o modification)
Need advices also for my Orion 10.5 motor, what are the good Gear and Pinion combination for the said motor?
Thanks alot.
In my manual the part # is 51104
But the only part available in our LHS is design for TA-05ifs with part # 51297
Can i used the ifs part for my TA-05r? (w/o modification)
Need advices also for my Orion 10.5 motor, what are the good Gear and Pinion combination for the said motor?
Thanks alot.
Last edited by DJ; 11-08-2008 at 06:50 PM.
#9878
Tech Adept
Mamba Max 7700Kv, Losi Xcelorin 3.5T or a Novak GTB 3.5T, which is better to put in a TA05 with aluminium outdrives?
#9879
Tech Elite
iTrader: (1)
Join Date: Mar 2007
Location: Bristol, England, United Kingdom
Posts: 4,857
Trader Rating: 1 (100%+)
#9882
Tech Master
iTrader: (9)
For those that are interested..
Using 6mm of spacers under the battery bar posts and the battery hold down piece from the TA05MS (completely flat, no shaped cell pieces on one side like the standard TA05 part) and you can fit tall lipo packs with large capacities like the LRP 5300 and TrakPower 4900/5400s etc.
Its a perfect fit once the above is done, required no dremelling of the slots to take out the shaped pices for NiMH cells.
-Mark
Using 6mm of spacers under the battery bar posts and the battery hold down piece from the TA05MS (completely flat, no shaped cell pieces on one side like the standard TA05 part) and you can fit tall lipo packs with large capacities like the LRP 5300 and TrakPower 4900/5400s etc.
Its a perfect fit once the above is done, required no dremelling of the slots to take out the shaped pices for NiMH cells.
-Mark
#9883
Guys/gals,
Tamiya only has the wide pitch pulley for diff and one-way, not for spool. does it make a significant difference for spool?
Tamiya only has the wide pitch pulley for diff and one-way, not for spool. does it make a significant difference for spool?