New CRC Gen Xi 12th car.....
#588
Tech Regular
iTrader: (16)
At Leisure Hours with the full straight my fastest set-up was;
Revtech stock rotor, 4.79" roll-out, centered on the third timing dash.
For the car I would start with Andrews nats set-up from last year.
Definitely have a white center and blue sides handy....
Paragon and tweak, or Paragon and SPF 50 are good tire preps. 20+10-20 minutes rear and 10 + 10 minutes front. <---- Huge tuning aid and lots of personal preference here....
Mike Slaughter
#589
Tech Champion
Wow this thread hasn't seen action in awhile...ok well lets bump this up!
I just ordered me a Gen Xi and plan to run it in 13.5 blinky at the IIC. Anyone have a good setup for this track? I imagine it will probably be somewhere between last year's 13.5 boost setup and 17.5 blinky setup.
I just ordered me a Gen Xi and plan to run it in 13.5 blinky at the IIC. Anyone have a good setup for this track? I imagine it will probably be somewhere between last year's 13.5 boost setup and 17.5 blinky setup.
#590
Tech Adept
Just wanted to let everyone know about our new 12th and 10th scale pan car tire truing adapter. This really helps get a true running tire by clamping the wheel the same way as when the wheel is attached to the hub with the mounting screws. Check it out at www.teamtamale.com.
#591
Tech Elite
iTrader: (49)
Just wanted to let everyone know about our new 12th and 10th scale pan car tire truing adapter. This really helps get a true running tire by clamping the wheel the same way as when the wheel is attached to the hub with the mounting screws. Check it out at www.teamtamale.com.
#592
Tech Rookie
short question
Hi, i started building my Xi yesterday. And just have the problem that the rear pod does not move completely free. damper, side-bars,... are "loose" on the kingpins. any ideas? Thank you
#593
Tech Champion
Put the chassis flat on a setup board and loosen the nuts on top of the center pivot. Make sure it is sitting flat and tighten them again. See the part on page two on "Setting the One-piece links". If that doesn't do it check the center pivot itself and make sure you haven't over tightened the screws that capture the pivot ball. The center pivot should pivot easily with very little slop in it.
#594
Tech Rookie
..
thank you! problem is solved. i have another question: has anyone ideas how to fix an sanwa/airtronics srg-hr servo? is there a bulletproof method?
#595
Tech Champion
Are you saying the servo is broken or that you are having a hard time getting it mounted correctly on the chassis?
#597
Tech Champion
#598
#599
Tech Champion
iTrader: (91)
Just wanted to let everyone know about our new 12th and 10th scale pan car tire truing adapter. This really helps get a true running tire by clamping the wheel the same way as when the wheel is attached to the hub with the mounting screws. Check it out at www.teamtamale.com.
#600
Tech Champion