3 racing new F1
#1321
Tech Master
i want to use the groove tire on the rear and the front of my rabbit but groove tire will not fit to f104 front rim. i change steering knuckle to f103gt that will use a bearing,m05 rear axle with pin to attach 12mm wheel hex. now i can use the f10 wheel set with shimzu groove tire at each end of my car i know not of hpi tire. are they good like shimzu?
thanks
thanks
#1323
Tech Adept
http://www.rcmart.com/rc-tires-10283...h=595_737_1415
any one with any experiance?
#1324
Tech Master
thanks for that.i would take the level of price that these are not very good traction?
http://www.rcmart.com/rc-tires-10283...h=595_737_1415
any one with any experiance?
http://www.rcmart.com/rc-tires-10283...h=595_737_1415
any one with any experiance?
#1326
Tech Adept
can ride tire fit the hpi rim?
thanks
thanks
#1330
Tech Elite
iTrader: (2)
UF1 Series
5th Race of the UF1 Winter series this Saturday in Chino California...
http://uf1series.com/index.html
http://uf1series.com/index.html
#1331
#1332
Tech Master
Its not the bearings its the plastic hexes. They wear out very quick and press into the bearing instead of the pin. Had this problem on the fgx and the zero s. Get some aluminium hexes and you will quit blowing bearings.
#1334
Tech Elite
iTrader: (9)
I'm using Corally hexes with alloy knuckles. The bearings flap around just as badly as the plastic because it's the axle that's 3 thou smaller than the ID of bearing !! Still pissy bearings of that size. I went thru a period of massive traction rolls that managed to pull the axle right thru the inside bearing turning my car into a tripod. Not so very good.
Jacko............
Jacko............
#1335
Tech Adept
does anyone else find some movement of the rear arms on the hinge pin?