The smallest you can go is 60T, and you then cant go any lower then a 42t pinion with a 60T spur installed without modifying the mount the mesh isnt close enough.

and a 42t pinion is the biggest you can go without making the motor screws too difficult to get to.

I know this as i run it on a 21.5 blinky on larger tracks :eek:

Beth.

Thanks everybody!!!! I hope to race/play tomorrow!

I did it! what a great time I had Driving the DUALSKY TC6. This is an amazingly responsive car. With my Z5 17.5 i had Plenty of motor to go faster! kinda scary haw fast it could be.... Good times!

will a novak http://www.amainhobbies.com/product_...-ESC-w-X-Drive and sr 300 rx fit on the left side fine the esc looks a tad big in the lay out?

The dimensions are in the ad you posted. Most ESCs like the LRP SXX, Castle Mamba Max Pro, Hobbywing v3 fit no problem. If the ESC you like is close in size you should have no problem.

Has the issue with the new plastic been fixed yet? Sorry I havent followed this thread since the 6.1 came out. Getting ready to start up onroad soon though so I need to get a car.

That esc says it is designed for short course trucks... Is that the right link?

yep its the right one. to run a novak 540 4.5 trun. is there a better novak esc i need to look at?

Go with LRP..... Blue is better. :D

what lrp set up to look at? and 5.5 trun too

Right now the LRP TC Spec v2 bit I heard the new LRP FLOW will be the one to get...

Here is a funny video of a dialed TC6 at West Coast Raceway

http://www.youtube.com/watch?v=PLU5C...feature=relmfu

How do u get all the play out of the front caster blocks and the rear hubs. I have a lot of play is this normal.

I am impressed! With the right tires this car would have been hard to beat! xD