Hi guys the new hobbywing stock supercharge software is now available for download .

these are the benefits .unitil its loaded on the hobbywing site you can send me an email and ill email you the software back .

thank you for your time

regards Angelo

Please check your PM

Please check your PM.

Hello, Cobraracing

You are so quick to put the news on the forum, thanks for your help. It is super slow for us to browse RCTECH forum from China, so please help us to answer some techinical questions from customers.

Powered by 2s lipo, a brushless motor runs at 120000 RPM. Can you believe it is only a normal 11.5T stock motor?

Normally, it should runs at 26000RPM. 120000 RPM is really incredible!

But we are not making a joke. Hobbywing just released a Beta version firmware for 1/10 on-road stock applications. It is an innovation for Stock technology!

If you have Hobbywing XERUN-120A (V2.0) or XERUN-60A (V2.0) ESC, and a LCD program box, you can download the new firmware freely at the following hyperlinks. You needn't buy a new ESC at all. Just save your money!

New Stock Firmware:
http://www.hobbywing.com/upload/soft...eta_100429.rar

The instrcutions of this new firmware:
http://www.hobbywing.com/upload/manu...-Hobbywing.pdf

Try it, and Trust it! (TNT ?! Yes!!! )

Let's enjoy the fastest speeeeeeeeed!!!

I suppose this works on a Speed Passion ESC?

I suppose it can go either way since the XERUN guys put SP software on their ESC, but I am sure the SP guys will say stick to SP software on your esc.

Will it run on EZRun ESC 30A too?

As long as you run a stock motor, maybe yes. The software is made to use the sensor of the motor and Xerun ESC's....

yes !

I just ran the 1.61 beta software...
Did not test it yet (actually I tested the "older" 100422 just yesterday on my bike with the Xerun 60A and Nosram 13.5T, see the HW Xerun thread).

so, the 1.61 contains three sw's: V1.10 205 mod, V2.0 422 stock and V1.10 323a_m

I installed the 422 stock to my 1/5 bike, and for the first time the "Apply" button is not greyed, and it didn't ask me to "upgrade software".

I may have some time to test it later today.

I took some screenshots...
Also note that the LCD Program Box now says V1.05_100420 on the initial screen.

HW motors can run at 120K rpm without grenading???

Can anyone tell me if you can use the Speed passion LCD programming box to program the Xerun 120amp ESC?

yes you can .same unit

yes of course Hobbywing is the creator of the SP and the software will work .