The Speed Passion Thread
#6691
Official Speed Passion Website :
http://www.speedpassion.net/en/produ...802PROSb&c=ESC
#6693
so... still no prices on the new sportsman v3 motors?
#6699
Talk about case,
Solara, Will Speed Passion release Case gasket, for SP GT2.0 and GT2.1 ?
Shielded case or something like that...
ex: "Highly water-resistant case with protective silicone gasket"
Solara, Will Speed Passion release Case gasket, for SP GT2.0 and GT2.1 ?
Shielded case or something like that...
ex: "Highly water-resistant case with protective silicone gasket"
#6700
I would highly doubt it. A sealed case would be useless since water can still get in the top through the sensor connector, switch and rx ports.
#6702
as i found a disturbing sensored socket by flood of water, will result
only sensored disabled and switch to sensoreless.
no electricity shortage may cause burned. (safety technology)
Unless the one at the rx wire sockets and fan sockets.
and yes the switch wire.
#6703
Hi there I am new to EP and I need to change the end/timing bell on my new sp 13.5T motor. How do I go about this?
Thanks
Thanks
#6704
dont forget to tighten the 3 screws BUT not too much
#6705
hey guys i have the GT2.0Pro with the stock softwere in it and my question is i am trying out tomorrow with my 6.5 motor and i want to know if it is safe to run in this setting or should i switch back to the mod firmwere into it
Thanks Phil
Thanks Phil