The Speed Passion Thread
#5371
Tech Regular
#5373
Tech Master
iTrader: (37)
Thanks.
John
#5374
Tech Regular
Yes, I wasn't clear. A local racer who has the LCD program box will be upgrading the software. I was wondering if all of the items and values will remain the same after the upgrade to version 528. My program card has a slider with the chart for the various items and values. I'm wondering if this is going to change.
Thanks.
John
Thanks.
John
#5376
Yes, I wasn't clear. A local racer who has the LCD program box will be upgrading the software. I was wondering if all of the items and values will remain the same after the upgrade to version 528. My program card has a slider with the chart for the various items and values. I'm wondering if this is going to change.
Thanks.
John
Thanks.
John
the rpm values in rpm delay is also changed, I don't remember what they are.
#5377
#5378
#5379
altreyx, you think we can get a revised ESC Setup Sheet to reflect the new RPM Delay range?
Thank you in advance.
Thank you in advance.
#5380
right because for 13.5T :
motor manual FDR for non stock is : 4.8~6.0 >6cell
SC SUGGESTED SETTINGS FDR : 6.5~7.0 >6cell
so 5.4~6.0 is in range for NoTiming & 205, but never use it for Stock Soft SC.
#5381
Done!
I released it some days ago, just forgot to put it online
Sorry.
PS: under the SC Punch (#15) i just added the voice that i read on the LCD program card, so should be more easy now read the value.
#5382
Tech Regular
Ok thanks, out of interest for the 10.5 they suggest 5.5-6.0 is that correct, ?I thought you need to gear it down for the lower turn motors ?
#5383
motor manual FDR for non stock is : 5.2~6.2 >6cell
SC SUGGESTED SETTINGS FDR : 5.5~6.0 >6cell {with condition Lower DMTS #9(5) 12°}
#5384
The suggested gearing sheet/manual provided with the motor is for non Supercharged software. These documents have not been updated in years and are applicable to the original non SC firmware and in some cases even the older V1 esc.
#5385