OK so a bigger rotor has more torque and smaller has less torque but more rpm right? I can see two possible rotors I can get for my 17.5mmm. One is the silver/purple super 7 and the other is a silver/red rotor. So which of these two would be better for use in stock 17.5 blinky touring?

For those who are interested in, here is the way to put MuchMore software in your Reventon Pro ESC:

http://www.petitrc.com/reglages/spee...eSoftware/eng/

I did this thread and the upgrade, it seems to work properly. For any questions or suggestions, please contact me by MP or by mail at jeremy.francoisnavez [at] hotmail.com

Best Regards,
G-rem

This is becoming a joke now. Absolutely no customer support here in Australia.
After numerous emails to a few different Speed Passion email addresses I have not received ANY help!
I have a product that is completely useless and my warranty is running down quickly. Have had the Reventon Pro ESC go up in smoke after 1 week of use and a V3 7.5r crap itself 2.
I really need this issue sorted, so if a speed passion rep is reading this can you contact me ASAP.
sincerely
One unhappy customer

If you bought this in oz I can see your frustration but if you got it offshore I can't see speedpassion Australia wanting to touch it. Did you make a phone call?

It was purchased from the Speed passion website but from there Australian distributor. I rang the distributor here in Aus and they said to email [email protected], which I have done numerous times which has gotten me no where.:flaming:

Are you saying they don't reply to your email?

I ask because I emailed them monday and they replied within an hour.

Yep,that is correct. have sent about 3 emails over the last week and a half

If it was purchase here then you are coverd by Australian law. So I would send them a email or call them direct again.tell them that you intend to go to fair traiding or whom ever will listen to get it sorted. Did you pay with PayPal (just another avenue for you to get a response ).

Ahh good point. Yeh I paid through paypal, will open up a case.
Hopefully that will get a response from them.

Most people on here are US based. Hopefully something can worked out.

Thank you for your answer i entered safe mode on program but still pc doesnt see the esc to recover firmware just program says entered sade mode and i have old led program card i updated program card. when i plugged esc and pc to card it says " - " what should i do ? (i tried that holding value button for pc mod it didnt work..)

regards..

weres a good place to order for Speedpassion stuff.

there main usa store wants retarded shipping...

looking for the sensor board +40 degree for V3 motor specifically.

Question:

I've been out of the hobby for over a year & I picked up a Speed Passion GT 2.1 pro stock in a trade. I was going to sell it to buy the Orion R10 but wanted to check to see if this esc is just as good as the Orion esc. I'll be running 17.5 buggy if that helps.

Thx...

Reventon Pro: is it possible to raise voltage cutoff?

I think the shipping price changes once you enter zip/address.


As for lack of response to emails: I have been accused of such only to find the emails that were sent were getting blacklisted/junkmailed.

gt2.1 is great in stock.....as far as smoothness and over all usage. No way. The 2.1 is a generation back. The Rev Pro would be the SP equivalent(shhh dont tell SP but the orions are better IMHO :P ). Yes Ive owned all three esc's mentioned.