YoDog

iTrader: (28)

Send a PM to Solara.
He is the US distributor.

skypilot

iTrader: (14)

Solara, aka Howard Lo, and his side kick Albert, yes I know,

but he has to log onto rctech to check his PM's and this thread is on the same site, sooooooo.

and before anyone says it, because they aren't answering emails, thats why

Big Lee

Just got some new batteries, they have the polarity of there tubes on opposite sides to the battery I was using. I didn't notice when I went to hook my speedy up. Sparked so I instanly pulled it away. I hooked up my original battery but the capacitors smoked up big time. Please Please tell me I've only fried the capacitors and not the speedy.

scoyle

Funny enough (well not that funny!) I did the same thing yesterday. I put another capacitor on from my other SP GT2.0 and used it for the rest of the day no problems. So hopefully yours is the same.

Big Lee

That is refreshing to know, I hope I do have the same luck.

JAM Racing

iTrader: (2)

does the revention esc have Roar approval and if so when will it be listed

scoyle

Reading the Speed Passion site it says that the Stock 1 setting is not available yet - I assume this will be for boosted 10.5 etc?

Is the Revention R being used for 10.5 touring car and if so what settings are people using?

JAM Racing

iTrader: (2)

need a reply as i will have to purchase something soon

M-Technic

iTrader: (15)

I believe there is only blinky software for the Reventon right now, as they are still testing the boosted software.

dc661

iTrader: (156)

I got the card, programed my esc then ran it for the first run. After about 3 minutes the throttle died. There is no over heat protection on in the settings and the battery voltage was still high. I waited tried again and still no throttle. So I tried resetting my throttle and after holding the set button on the switch it never goes into the set mode. Any Idea of what is wrong and why it will not go into the throttle range calibration?

yogii

iTrader: (4)

Im running blinky mode on my on road car, with a 17.5 speed Passion V3 motor. I would like to know witch sensor unit would be best for blinky mode to give power, and acelaration, and keep motor cool. I realize I'll have to have a fan on motor.

M-Technic

iTrader: (15)

The yellow +30* timing board seems to be the most popular for 17.5 blinky.

yogii

iTrader: (4)

Thanks, will order it.

Solara

iTrader: (17)

Capacitor came with the ESC...and the sensor cable also came with the MOTOR...however, if you are running F104X1, you will need a longer one like the 180mm....the sensor cable that came with the motor is the 90mm one that usually is short enough for TC...but F1 need a long one. You will need this...

http://www.speedpassion.net/us/produ...p=162801&c=OPT

Solara

iTrader: (17)

Ritchie, please check PM.