The Speed Passion Thread
#242
Tech Adept
Software Updates
Can someone let me know where on the speed passions website the software updates are.
Regards
Michael
Regards
Michael
#243
Tech Adept
Software Updates
Last edited by miku; 05-28-2009 at 12:57 PM. Reason: Duplicate Post
#244
its listed under the top heading "apparel"
#245
Running brushless motor without load.
Adam.. I have just purchased speed passion brushless analysis tool. and when I wanted to run the motor checker function. the motor was connected without any load and running at full speed for few seconds during the test.
Some say that it is not recommended to put full throttle on the brushless motor and let it run for few seconds, it will damage the brushless motor.
what is your comment on this?
Thank you
Some say that it is not recommended to put full throttle on the brushless motor and let it run for few seconds, it will damage the brushless motor.
what is your comment on this?
Thank you
#246
R/C Tech Elite Member
iTrader: (37)
I have never personally damaged any motors using the brushless analysis tool, and I have run some motors over 3-4 minutes at a time.
I have read and I have been taught the same message about keeping "some" sort of load on it, which I do try to whenever I use the brushless analysis, or even my vehicle.
So I would make a conscience effort to follow that rule to make sure that your ESC and motors last as long as they can.
I have read and I have been taught the same message about keeping "some" sort of load on it, which I do try to whenever I use the brushless analysis, or even my vehicle.
So I would make a conscience effort to follow that rule to make sure that your ESC and motors last as long as they can.
#247
Tech Master
iTrader: (1)
Adam, Shawn Thanks for all the help you guys sent to Toni for the Reedy Race. She has been real busy getting ready for exams in A-School. 3)B+'s and 2) A's on the exam the day after returning from the race. She finished dead last in 13.5 and had a blast. Charlie B helped her finish up her esc setup and get her car ready for race. She would have typed this herself but she is a Slacker. . I'll have her try and call during the week .
#252
How do I know which version of the software I am running?
Anybody seen Adam lately?
Anybody seen Adam lately?
#253
just want to say thanks to Shawn and Adam for a incredible turn around on some ESC and motors we had isses with. this is our first experience with service of product and these guys earned an A++++++
Thanks guys
TZR
Thanks guys
TZR
#254
Tech Fanatic
anybody got a good stock set up on gt pro2. esc
hi guys anyone got a good stock setup on ur gt pro2. esc to share ur settings running 17.5 thxs reggie