Chris08527

iTrader: (16)

yea right, watch the vid somewhere and watch scooby reel DJ in the length of the straight for 2cd overall . . .that was D3 vs. Fastest D3 . . .

bpalmer

iTrader: (1)

could not find revtech packs in time so i settled on an orion 90c , also cranked endbell timing.... much better, thanks... gonna go with jackson setup for next week...oh yea, where is the best place to buy the revtech motors ?
thanks hanulec !

hanulec

iTrader: (28)

Express motorsports and ea motorsports have revtech packs and motors all of the time..

bpalmer

iTrader: (1)

have to wait a few days...express shows pre order only and ea website inop...

Buckaroo

iTrader: (3)

I ran the set up that Hanulec posted a few pages back, servo in standard position, with a change in springs. DIALED!

locked

iTrader: (1)

nexusracing.com have some ReVtech motors and ReVtech batteries in stock right now. They are also the only place i've found so far that sells LG1 and LG2 (Paul Lemieux's traction compounds)

Buckaroo

iTrader: (3)

What's the smallest 64P spur gear that will fit?

locked

iTrader: (1)

I have a 90T spur in one of my cars. Could probably fit one a few teeth smaller, depending on the type. I use spurs made by "Precision Racing Systems". They are the same thickness throughout. With this type you could go down to a smaller size than the standard ones that are thicker around the circumference. I'm not sure what the absolute smallest would be though before the corners of the pulley pieces start getting in the way. I would guess somewhere in the mid 80's. I know with a 90 I can get down into the low 3's for FDR. Largest pinion I own right now is a 53 and that will fit with the 90 spur, no problem.

Hope that helps a little.

SRW141

iTrader: (4)

I have an 84 spur in my car. I have also ran a 78 spur.

MikeXray

iTrader: (73)

76 is the absolute smallest.

locked

iTrader: (1)

Wow. I was way off. Good to know. Could run some ridiculously low fdr with a 76.

Thanks Mike

EAMotorsports

iTrader: (79)

Thanks for the support Mike.

Website was taken down a while back. Not really worth paying to have rebuilt. Anyone interested in products can contact me on here or [email protected]

Thanks
EA

bpalmer

iTrader: (1)

email sent..

Buckaroo

iTrader: (3)

What's the difference between the PCH20R rubber spec and the PCH20H hard foam bumper?

rc_square24

iTrader: (9)

The rubber one is like the standard bumpers that come in other cars, hard one is like its name says... really hard foam. Kind of like the foam sanding blocks they have in body shops, best I could think of now.