Ko BMC Speedo
#226
Tech Master
set th. epa to 80% and recalibrated esc... no difference at all.
Guess I have to send it in to KO for an upgrade/repair.
Guess I have to send it in to KO for an upgrade/repair.
#227
#229
Tech Fanatic
iTrader: (5)
Join Date: Aug 2001
Location: Beautiful Downtown L.A. Where the sky is always on fire and the grass is always brown
Posts: 949
Trader Rating: 5 (100%+)
#230
Tech Adept
Lipo Cutoff
Hello,
What is the voltage cutoff value when lipo cutoff is selected?.
I ran the car till it hit lipo cutoff, but when i put the pack back on the charger it read about 5.8v . Is there a way to set the voltage value to like 6.3v ?
Thanks Ya`All
What is the voltage cutoff value when lipo cutoff is selected?.
I ran the car till it hit lipo cutoff, but when i put the pack back on the charger it read about 5.8v . Is there a way to set the voltage value to like 6.3v ?
Thanks Ya`All
#231
Speed Control Profiles
Just wondering what happened to the web page with the different SC profiles? Can't seem to find them anymore.
#232
me either. I can't find it anymore..Did they move it??
#235
#237
Tech Adept
The new timing settings are adjustable from 0-6 with the new firmware, not sure if there is any difference though. My guess no, just more values to advance the timing higher. I did notice with the BMC software that WAS on the KOPROPO site only allowed me to adjust the timing from 0-2, even though my setting was at 5. I saw they put the software back up, I wonder if this will recognize if a speed controller has the new firmware and allow timing adjustment 0-6?
#238
The new timing settings are adjustable from 0-6 with the new firmware, not sure if there is any difference though. My guess no, just more values to advance the timing higher. I did notice with the BMC software that WAS on the KOPROPO site only allowed me to adjust the timing from 0-2, even though my setting was at 5. I saw they put the software back up, I wonder if this will recognize if a speed controller has the new firmware and allow timing adjustment 0-6?
good question, i am waiting for my escs to return, and with them should be a control wire....i have the software downloaded on my computer, it never occured to me that it may be different on the new esc....