XRAY T2’009
#1789
#1790
Tech Initiate
I have the 09 foam tire version & I put Jaco foams #6160 on the front & they hit the steering arms, the manual tells me to put the tires on a tire truer or file them down. I don't have a tire truer so how are you guys doing this, looks like a lot has to be taken on the inner tire & rim. I checked the shims in the front & they are correct, the front tracking width is 189mm, this is correct.
Thanks
Thanks
#1791
Tech Master
iTrader: (18)
T2-09 Rubber. Everything is loose and EPAs are set. After playing with it further it only does it at low speeds. If I'm on throttle it does not chatter while steering, only while going slow.
My guess is ECS may be needed but i'll deal with it for now before I drop even more money on a new car
My guess is ECS may be needed but i'll deal with it for now before I drop even more money on a new car
#1792
Tech Master
iTrader: (17)
T2-09 Rubber. Everything is loose and EPAs are set. After playing with it further it only does it at low speeds. If I'm on throttle it does not chatter while steering, only while going slow.
My guess is ECS may be needed but i'll deal with it for now before I drop even more money on a new car
My guess is ECS may be needed but i'll deal with it for now before I drop even more money on a new car
#1793
Tech Master
iTrader: (3)
I have the 09 foam tire version & I put Jaco foams #6160 on the front & they hit the steering arms, the manual tells me to put the tires on a tire truer or file them down. I don't have a tire truer so how are you guys doing this, looks like a lot has to be taken on the inner tire & rim. I checked the shims in the front & they are correct, the front tracking width is 189mm, this is correct.
Thanks
Thanks
#1794
Tech Lord
iTrader: (52)
Cpt.
#1796
Tech Master
iTrader: (18)
You used WAY too much loctite on the grubscrews in your driveshafts, and it has turned all the grease you put on the joint into glue. You need to dissasemble your driveshafts, scrape all the grease out (which is now glue), and start over. only used the TINNIEST drop of loctite on the grubscrew, and make sure you wipe up any excess before you grease your shafts.
Cpt.
Cpt.
#1797
Tech Lord
iTrader: (52)
cpt.
#1798
They are also a bit more delicate than the factory items in my opinion, so not givveing them to every cretin to destroy is probably a good thing.
Skiddins
#1800
Can't say I buy this 100%. Maybe my ta05 was magic. The 007 I had, however, rattled like crazy.