wingracer

iTrader: (24)

I have never had an actual spektrum radio, but most all of the better radios on the market beat the spektrum module systems. Maybe the complete radio is better. I'll stick with Airtronics FM or maybe give KO a try.

20 SMOKE

iTrader: (103)

i have a dx3s and and r1 on crystals only have my brakes set at 50% so they dont lock up

niznai

There is no comparison. The Spektrum was so slow I just couldn't use the speed of my steering servo. Mind you that was a DX3 Spektrum which is a rather old radio. Newer Spektrums are better but still below the KO. The Spektrum also had problems with losing binding for fractions of a second which can't help. I can tell you that just by changing the radio I shaved about 1 second a lap on our track.

higbo

When you refer to KO... the system ko is 2.4mhz or FM?

niznai

2.4GHz but that's irrelevant. The reaction speed of the radio is what makes the difference not the carrier frequency.

Donny Lia

I used profile 4. Should point out however that throttle profile is strictly throttle curve mapping and has no effect on motor timing etc...

edit:forgot to say really just driver preference

Jeremy Otis

Question for Randy or Yang

I am running 1/12 scale with a 2 cell receiver pack plugged directly into the receiver with no regulator. Is this to much voltage for the speedo. In other words am I risking buring it out?

I know I am already taking the risk with my JR servo.

Thanks

Still Bill

iTrader: (16)

With my Tekin RS driven WGT, I use the Trinity/Epic Li-Fe receiver pack. It's voltage is only 6.6V and does not require a regulator. And I use the JR servo too. No problem.

Bill

hi-tech-redneck

iTrader: (1)

ok....i read here somewere that you could download v203 once you signed up at the tekin site. the only thing i see to sign up for is the forum witch i did but i don't see anything stating downloads ,do i need to ask?have a secret hand shake,stick my tounge out of the other side of my mouth?????last time i upgraded i just sent randy a p.m. and he sent me back a link.also anyone have a good starting point for v203 for 1/12 scale 1s lipo,outdoor,large track with 120ft strait and both tight&open tech sections.just a starting point,with all the advise on this site i should be able to tweek it from there.

vabroom

Try this:
http://teamtekin.com/hotwire/vegas/index.html

or this:
http://teamtekin.com/hotwire.html

HoboShop

iTrader: (3)

Does anybody have or know a good base setup for a tekin redline 17.5 motor with v203 software. I run the tamiya 416 we. Also is this a good motor to start out with compared to the trinity duo2 and the Lrp x12.

Still Bill

iTrader: (16)

You will receive an e-mail from Tekin with the link. Not sure how long it took for me to get mine...An hour or so during a weekday.

Vabroom's first link above gets you there too.

Bill

wingracer

iTrader: (24)

I'm not Randy or Yang but the esc doesn't care. If your Rx and servo can take it, you're fine.

or8ital

iTrader: (38)

I owned the KO 2.4Ghz stuff for a couple years and have switched to a Spektrum DX3R. I don't notice a difference at all.

20 SMOKE

iTrader: (103)

i like the redline over the duo2 but it is a good motor what i am using is
timing boost 50 motor 0-4deg
turbo 10
delay 4-5
ramp 2
start 2500-3k
end 10k-11k
fdr 5.5-6.0