SMC 28C 4000/5000 Hardcase Lipo part 2
#1171
The heating element can get pretty hot, so the foam is good. The heat transfers through the hard case pretty well...you can feel the heat on the top of the battery after it sits in the tray for a little while.
#1173
Team EAM
iTrader: (79)
#1178
#1181
Tech Champion
iTrader: (32)
I TQ'ed the last time out but had some issue's in the main. My 5000 pack was awesome all day. This time I might balance charge it just to make sure that it's completely race ready to lay the smack down since alot of trash talking has been going on.... I have my new Novak goodies coming in this week along with a new body and I have a new radio as well. Too bad I still have my same piss poor attitude Danny better get his inventory ready because after this weekend everyone will want what they got beat by...... Thanks again for the body info.
#1183
Danny what was the reasoning for the guys running for smc to run the 5000 lipo ?
Just curious cause logic would say that a 2s1p(4000) would have lower resistance than a 2s2p(5000).
Maybe i am wrong, and if i am can you please drop some knowledge on me cause i am very new to lipo
Just curious cause logic would say that a 2s1p(4000) would have lower resistance than a 2s2p(5000).
Maybe i am wrong, and if i am can you please drop some knowledge on me cause i am very new to lipo
#1184
A 2S2P will not have higher IR than a 2S pack. When it comes to Lipos the bigger the cells the better they will be as far as IR. So our 5000 has better IR and voltage than our 4000. That being said some racers did use the 4000 with good results at the IIC.
#1185
Tech Elite
iTrader: (8)
Danny what was the reasoning for the guys running for smc to run the 5000 lipo ?
Just curious cause logic would say that a 2s1p(4000) would have lower resistance than a 2s2p(5000).
Maybe i am wrong, and if i am can you please drop some knowledge on me cause i am very new to lipo
Just curious cause logic would say that a 2s1p(4000) would have lower resistance than a 2s2p(5000).
Maybe i am wrong, and if i am can you please drop some knowledge on me cause i am very new to lipo