Alex Racing Barracuda R2 & R3
#5611
So the R3 will come with this already front and rear, no more plastic shaft holders??
#5612
Regional Moderator
Originally posted by forty6
So the R3 will come with this already front and rear, no more plastic shaft holders??
So the R3 will come with this already front and rear, no more plastic shaft holders??
#5613
Tech Master
The Speedway Pal drive shaft system that Steve sells, is it just right hand conversion, or does it come in a left hand version?
#5615
Tech Master
Thanks. Didn't want to order it and not be able to use it.
#5617
Tech Champion
iTrader: (9)
Originally posted by Randman
I didnt even realize that PAL made right hand versions anymore, I thought the Web Special drivetrains were the only ones.
I didnt even realize that PAL made right hand versions anymore, I thought the Web Special drivetrains were the only ones.
#5618
Regional Moderator
Originally posted by Randman
I didnt even realize that PAL made right hand versions anymore, I thought the Web Special drivetrains were the only ones.
I didnt even realize that PAL made right hand versions anymore, I thought the Web Special drivetrains were the only ones.
#5619
Tech Initiate
64 pitch
hello all, any-one have a "par" chart for running 64 pitch on a cuda w/ stock motor, carpet? was thinking about switching but don't have a clue. example, 72-25 is the same as 101 and ? or how-ever you figure? thank-you.
#5623
what is the smaller hole on the R1 holder used for?
#5625
Originally posted by racer
what is the smaller hole on the R1 holder used for?
what is the smaller hole on the R1 holder used for?
Back from a night of "racing" not a good night at all, for the first time in something like 6months I was in the B final just couldn't get the car going nicely and the track layout was not helping one bit. On power understeer, off power oversteer, medium power not bad until it hit the sweeper at speed where the back end would occasionaly do a nice swing out. Improved things through the night but never got it nearly as good as it should be. Ahwell, a total rebuild for next week, time to start again...