Team Losi JRXS Type-R
Tech Elite
iTrader: (15)
Tech Champion
iTrader: (1)
I would be very interested to see how people go with this upper deck. From all the testing I have done I believe the car will be easy to drive, but have lots of high speed understeer with that much flex. They could have made a little more clearance for the bullet connectors as some packs have them right on the very edge. It does look nice though...
Hey Guys,
Been away for a few years and it looks like foam is no longer in.
Need to know if I need to buy anything (top plate) to make the car more suitable for rubber tire carpet.
I understand the setups are COMPLETELY different and I am working on that.
Been away for a few years and it looks like foam is no longer in.
Need to know if I need to buy anything (top plate) to make the car more suitable for rubber tire carpet.
I understand the setups are COMPLETELY different and I am working on that.
Tech Fanatic
iTrader: (11)
Tech Champion
iTrader: (17)
This piece looks excellent!
Tech Addict
iTrader: (1)
Haynes is doing good at vegas! We'll have a good carpet setup to start the indoor season!
Tech Elite
iTrader: (74)
No kidding looks great
Tech Rookie
7.4 v fan tip.
I like to run my fans @ 7.4v so the don’t interfere with the receiver. Also they spin much faster.
I use an old receiver board and connect the two undersides with solder then hard wire to the
ESC battery terminal. Just an idea take it or leave lol
And yes this completly off subject sorry just board today
I use an old receiver board and connect the two undersides with solder then hard wire to the
ESC battery terminal. Just an idea take it or leave lol
And yes this completly off subject sorry just board today
Tech Rookie
want a lower CG
Easy
Tech Champion
iTrader: (73)
Diff issues!
Need some help guys. I can't figure out what I am doing wrong with my Type R diffs. Just so u know I am waiting to the flyingfox spool and outdrives, but in the mean while I am running stock diff front and rear.
While at the track tonight, after about 5 or so mins of track time either the front or rear diff screw backs out of the outdrive. I re-tighten then same thing again. I ended up stripping the rear one which ended my night. Your help is appreciated.
While at the track tonight, after about 5 or so mins of track time either the front or rear diff screw backs out of the outdrive. I re-tighten then same thing again. I ended up stripping the rear one which ended my night. Your help is appreciated.
Tech Addict
iTrader: (2)
Need some help guys. I can't figure out what I am doing wrong with my Type R diffs. Just so u know I am waiting to the flyingfox spool and outdrives, but in the mean while I am running stock diff front and rear.
While at the track tonight, after about 5 or so mins of track time either the front or rear diff screw backs out of the outdrive. I re-tighten then same thing again. I ended up stripping the rear one which ended my night. Your help is appreciated.
While at the track tonight, after about 5 or so mins of track time either the front or rear diff screw backs out of the outdrive. I re-tighten then same thing again. I ended up stripping the rear one which ended my night. Your help is appreciated.
Tech Addict
iTrader: (2)
ok, I have got a picture in my mind of how u solved it. Obviously I am not the only one who has had this problem.