ACADEMY STR4 PRO2
#196
my str4 has rear heavy duty steel diff, center carbon shaft and a mod upper chassis for enhace grip.
#197
Tech Legend
iTrader: (294)
This one here isn't a bad starting point I found at least for VTA, using lighter springs:
http://www.modelrec.com/events/docum...o2_7_14_06.pdf
http://www.modelrec.com/events/docum...o2_7_14_06.pdf
#198
Thank you so much cain, next week i will make a setup for my track and i post it for everyone.
Greetings!!!
Greetings!!!
#200
i just posted up a WTB for a STR-4 PII anyone out there got one they want to get rid of.
Emaqil pics and Price to [email protected]
Need spares.
Emaqil pics and Price to [email protected]
Need spares.
#201
Tech Initiate
I'm prepping an Academy STR4 Pro II for touring car, rubber tyre, carpet racing indoors with 17.5 brushless motors. I've spoken to Cain previously on Oople about it, but are there any decent setups to start with? VTA is a bit different to this format, with foam tyres and GT bodyshells - I'll be on Sorex 28JB premounts with a Alfa Romeo 156 TC shell.
The one time I last tried it, grip roll was terrible, but I've learned a lot about setup since then, and have all the tools now.
Anti-roll bars are virtually impossible to find (certainly not this side of the Atlantic), so I'm hoping to adapt some Tamiya ones. I'll only need one on the front, probably.
The one time I last tried it, grip roll was terrible, but I've learned a lot about setup since then, and have all the tools now.
Anti-roll bars are virtually impossible to find (certainly not this side of the Atlantic), so I'm hoping to adapt some Tamiya ones. I'll only need one on the front, probably.
Last edited by colmo; 10-07-2010 at 11:59 AM. Reason: Alfa Romeo shell
#203
Tech Master
iTrader: (20)
I'm prepping an Academy STR4 Pro II for touring car, rubber tyre, carpet racing indoors with 17.5 brushless motors. I've spoken to Cain previously on Oople about it, but are there any decent setups to start with? VTA is a bit different to this format, with foam tyres and GT bodyshells - I'll be on Sorex 28JB premounts with a Alfa Romeo 156 TC shell.
The one time I last tried it, grip roll was terrible, but I've learned a lot about setup since then, and have all the tools now.
Anti-roll bars are virtually impossible to find (certainly not this side of the Atlantic), so I'm hoping to adapt some Tamiya ones. I'll only need one on the front, probably.
The one time I last tried it, grip roll was terrible, but I've learned a lot about setup since then, and have all the tools now.
Anti-roll bars are virtually impossible to find (certainly not this side of the Atlantic), so I'm hoping to adapt some Tamiya ones. I'll only need one on the front, probably.
#204
Tech Initiate
I haven't run it yet - my TA05 is the weapon of choice for the moment, and I picked up a TM E4JS cheap too!