I will do some recording of the class if I have some free time. :nod:

what T8 motor was he using at the time in the video

2250

I think the 2000kv with a 14t pinion will be the setup for this rig.

motor for etruggy
 

that's what I have in my Rc8t ce
on 4s

Truggy 2250 is a beast, I had one before, lots of horsepower!
trying to figure what motor to put in the new truggy when it is released!

1350, 6s, 14T :nod:

You could tell by the vid it's a high kv motor, it doesn't behave the same as a lower kv. I wouldn't go too low in kv with a tail happy car, or let's say a car that is a little loose from the rear. The torque provided by lower kv motors can be too much to handle when the track is slippery. In some (rare) cases a higher kv is better. I did quite a few testings with motors and I wouldn't use a big torque motor with a nimble car (this is what I run now and part of the reason why I'm switching for a more planted buggy). For a truggy you'll need a minimum torque of course but 2000kv should be perfect

1400 buggy motor on 6S :sneaky:

a buggy motor is a good idea considering the ET48 should be light!

True. I guess Im just used to my old xray truggy. This tekno truck should be a good bit lighter than that old tank.

yeah atm I am used my nitro convert serpent truggy till this one come out any more word on the date yet when it come out

truggy making a comeback lol. Tekno ... gonna be poor here soon!

yeah truggy is making a come back I reath drive a truggy then a buggy but I get both lol

that's the motor I have in my EB48. 2250 truggy. I think its really smooth

:eek: