BSCFlash

iTrader: (4)

Similar is defined as "resembling without being identical."

This can certainly be construed as "within the tolerance of 10%" for a noob to try out and experiment with. You wouldn't call them similar, but I would. Your definition of "similar" is different from my definition of "similar," and your opinion versus mine. I ran both and had absolutely no difference in lap times, and I doubt he would, either.

In the spirit of this forum, which is intended to champion the camaraderie of the hobby, perhaps you shouldn't overanalyze an innocent statement made by someone who is merely trying to help out a fellow hobbyist who had some basic questions.

skyler hays

iTrader: (12)

I drilled a hole in the fan case and screwed switch to case

dtr

OK Let him try and see how hee likes it.

BSCFlash

iTrader: (4)

Bingo! I know when we talk among experts, we can give actual gear ratios--like "3.00 to 3.07" and stuff like that--when talking about spurs and pinions. But when helping out newbies, we always try to keep it very simple as to not confuse them. That way they can try stuff and get a feel for what works at their particular track. Glad we are on the same page! Thanks!

masin14

iTrader: (22)

Thanks I appreciate it . I decided to go with the 45/15. They both felt the same to me but i could get a better mesh with the 45.

BSCFlash

iTrader: (4)

Great choice.

symmetricon

iTrader: (27)

Alright guys, Im picking one of these up and air have a few questions. 1 any reason to run the stock pistons over the 1.3x8 machined Losi pistons? Does the motor mount allow for 4mm screws into the motor?

symmetricon

iTrader: (27)

Alright, so how do I get my orion vst2 motor to mount when it only has 4mm screws to mount and the motor mount is 3 mm only?

Rockthecatbox21

iTrader: (19)

I built the car with stock 5x1.4 pistons up front and it felt way overdampened. I had some tekno 8x1.3's lying around so i'll be trying those this weekend. I felt my buddy'a car with the 8x1.3's and it felt much better.

symmetricon

iTrader: (27)

How are you liking the 3.0 at your track there?

hacker07

iTrader: (13)

Did you use actual TLR oil or the kit oil? This may cause it to feel stiff. The 5 x pistons for the front and rear are really meant for indoor. You will likely like the 8 x setup for outdoor better if that is where you are playing.

TY@TEAMTEKIN

Small dab of CA glue and put it on the side of the RX8 case.

symmetricon

iTrader: (27)

Which setup would be the best for Mikes in Porter Tx where the nitro nats were last year, Phends or Drakes outdoor setup? The track is medium to high bite and smooth when freshly built.

Rockthecatbox21

iTrader: (19)

I'll find out on my maiden run this weekend.

I took your advice and used oil not included in the kit. The rear feels great, but the front with 1.4x5 pistons and 37.5 ae oil felt overdampened still. I put in tekno 8x1.3's up front last night with 40wt ae oil and it feel much better on bench. I'll be putting it to the test this weekend. Thx for the help.

symmetricon

iTrader: (27)

So looking at Drakes's setup I can't tell the orientation of which way the 1s up and 1s down go...


does the dot up go in the front and the dot down go in the rear?