87MagnumII

iTrader: (9)

Teckno Cvd pins for the win. I've been running mine for ever with no trouble

Feint Motion

iTrader: (24)

Just want to say RIP to BCE Bill. Lost a great in the RC Community.
Heres my scte 2.0 with a BCE H1.

zuki250

iTrader: (3)

Hey guys...i anyone here running a 2 pole motor? I just killed my 4 pole revtech and looking for something else...I was going to go with a 4 pole Hobby Wing, but saw they offered a 2 pole motor. I hear they are smoother and easier to get power down with, but how much and i going to lose going from 4 to 2 poles?

Brian L

iTrader: (21)

Does anyone know who makes a graphite steering link with ball bearings?

kingofcool999

iTrader: (7)

http://www.vision-racing.net/product...59&id=35155320

Casper

iTrader: (34)

If you go 2 pole you will want to make sure you get a 550 motor. Yes they are smoother on the bottom end and can be a little stronger on the top end. They respond better to timing advance as well if you like tuning with your ESC.

I prefer the short can 4 pole. Saves some weight on the truck and tons of power. Bottom end is not over powering as you can do with a long can 4 pole and just a overall good motor. 2 pole are great of large 8th scale open tracks though.

.AJ.

I've just one of them for my truck, seems a good bit of kit

.AJ.

LAGuy

iTrader: (5)

I use the Novak 4.5. It runs excellent in the truck. It can be tuned using the esc very well for a variety of tracks.

Tommygun1

iTrader: (16)

I wonder where I can get the Orion 550 4.0T that Dakotah runs? I searched everywhere. I'm guessing they don't make it any more.

Dirtraycer

iTrader: (4)

whats a good ESC that wont break the bank and still reliable ??? I race indoor clay that's med - high bite.

Tommygun1

iTrader: (16)

These work good http://www.falconsekido.com/products...ished-xrsct-bk I've got a couple. Work great. They actually appear to be new units sealed in the package when you get them.

Tommygun1

iTrader: (16)

Can someone tell me if there's any other option available for getting these shock O-rings? http://www.amain.com/product_info.ph...ld-Set-2-Ten-T

And are these the correct rod ends for the 2.0 or is the plastic different? http://www.amain.com/product_info.ph...d-Set-15-Ten-T

kingofcool999

iTrader: (7)

I would highly recommend a 1/8 scale ESC, like the Viper VTX8 or Tekin RX8. Might save you trouble (and $$) in the long run.

monsterfarm

What do you guys think of running an Orion R10.1 esc in the TLR SCTE 2.0 with a tekkie 4600 motor? Is that pushing my luck? Or should it hold up well?