Originally Posted by Wildcat1971 (Post 11234225)

well timing is different from motor to more. some use those 3 long screws that can be screws in 3-5 different positions. Some are on the end of the motor near the 3 wires and is held in place by 3 screws. normally if the screws are loosed, you can rotate the timing on the end. take several pictures of both ends of the motor. and use them as a reference when reassembling. you can also video take your disassembly and the use the video to reverse your steps.

Originally Posted by Wildcat1971 (Post 11234287)

np. these motors do not even like a little dirt. had the same issue a few times. good luck.