Kyosho Ultima RB6 & RB6.6 Car Thread
|
|||
#976
Tech Fanatic
iTrader: (7)
I'm getting ready to start building and am looking for a little advice. I see a few setups around, but they are all for mod. Starting with Tebo's Nats setup(which is for outdoor mod), what changes would you guys make for a starting setup for running 17.5 on a medium sized indoor clay track. I know this is speculation, but I don't really have much experience in 2WD buggy.
Thanks
Thanks
#977
ahh yes... I didn't notice his question said Tebo's nats setup. If you/he are talking about his RB6 setup sheet from the super-nats, it is certainly indoor, clay, medium traction... a fresh track build at WCRC. THEE most amazing RC facility I've ever seen. I was lucky enough to be there! His RB6 was planted... but being cav's home track, he wasn't catching him... Cav was ridiculous.
#978
#979
#980
Is anyone here running Losi BB pistons with any success? Thinking about trying them. Let me know.
#983
ive seen an drove ryans, they look good but im stickin to my AE. so are you gunna run mod now that the series is over?
#985
#986
It's finished. Just got to paint the body and mount up some fresh bar codes.
The buggy is really heavy. I used Lunsford titanium screws everywhere to save weight. I have a set of the turnbuckles ordered. When its all done I will post a total running weight.
The buggy is really heavy. I used Lunsford titanium screws everywhere to save weight. I have a set of the turnbuckles ordered. When its all done I will post a total running weight.
#987
#988
Compared to my RB5
#989
Hello guys.
This might be a stupid question but... Does the kit include 2 bodies? Or only one?
I'm asking this because, since the car can be mounted as MM or RM i'm thinking if the kit could include 2 bodies for the 2 setups.
Thanks!
This might be a stupid question but... Does the kit include 2 bodies? Or only one?
I'm asking this because, since the car can be mounted as MM or RM i'm thinking if the kit could include 2 bodies for the 2 setups.
Thanks!