Kyosho Ultima RB6 & RB6.6 Car Thread
|
|||
#8851
#8856
Tech Master
iTrader: (33)
So I ran my 6 for the first time today. It seems to have too much steering, is there a way to tone it down a little bit? Other then that this thing is absolutely dialed. Best buggy I have ever drove. It hooks up awesome, flies absolutely great, and just feels so planted. Another thing, how do you guys keep the rear tires from hitting the wing when hitting a jump, and landing a jump? I used the stock holes and it hit so bad that I moved the wing back about 6 mm but it still hits.
#8857
Tech Champion
iTrader: (73)
So I ran my 6 for the first time today. It seems to have too much steering, is there a way to tone it down a little bit? Other then that this thing is absolutely dialed. Best buggy I have ever drove. It hooks up awesome, flies absolutely great, and just feels so planted. Another thing, how do you guys keep the rear tires from hitting the wing when hitting a jump, and landing a jump? I used the stock holes and it hit so bad that I moved the wing back about 6 mm but it still hits.
#8865
Tech Apprentice
lower shock balls
Is anyone using metal lower shock balls? If so are they any of the below:
KYOW0136 (hard steel)
KYOW0201H (alum)
SER1647 (Serpent steel)
SER804251 (Serpent alum)
TKR5058A (Tekno alum)
The Kyosho balls don't seem to have the short straight section on either end of the ball that the stock molded parts do, though if they're 5 mm wide that should be all that matters.
KYOW0136 (hard steel)
KYOW0201H (alum)
SER1647 (Serpent steel)
SER804251 (Serpent alum)
TKR5058A (Tekno alum)
The Kyosho balls don't seem to have the short straight section on either end of the ball that the stock molded parts do, though if they're 5 mm wide that should be all that matters.