I have not tried it again yet. Hopefully I'll get some track time this weekend if the weather cooperates.

Received the Justock speedo yesterday..Install was easy since its so much smaller than the Xerun. footprint is just slightly larger than a tekin RS.Seems to be no change in performance running everything else the same, just swapping esc.Will get to the track for some friday night racing tonight and test it out thoroughly..:)

well that went nice!! TQ first round, reset TQ 2nd round, and 1st in the main.Yep the justock speedo works JUST FINE in blinky 17.5 class.I even ran without the fan on it and the esc temped at 73* after a 5 min. run..

good stuff. think it will handle blinky 17.5 scts? any plans putting a hotter motor with it? what is the max burst amps it can sustain?

260a burst current.I would say yes it could deal with a 2wd SCT in blinky no problem.They are pairing this speedo with a 8.5 motor in their combos, so I would have to say that they are UNDERstating the ratings on the esc.Otherwise they would have to be nuts to pair it with an 8.5 as a combo.

If its anything like the HobbyWing 60A if you are going to use 8.4v you need a new fan. It says so on the Hobbywing site that the fan only works with 2s or 6cell and bellow.

Thats the one I want, currently out of stock. So I'll give it a wait.

Does anyone know if the OEM Speed Passion Field Programming card works with the YELLOW Ebay motor/esc combo for $77.99?

i'd say yes

Hey guys i have done some searching and I have imported a gross of the 60a and 120a controllers with the usb link...:sneaky:Thats why I havent posted in a couple weeks..alll speedos will be tested before shipped to make sure there will be no start-up issues for people like a doa controller etc...They are the same as the yellow Ebay combo(no motor) except the controller cases are black for the 120a and a translucent purple for the 60a..The usb adapter is yellow just like the ebay combos...PM me if you happen to need a good speedo without the 2 weeks shipping from china!!Here are a couple pics of the 60A.The 120's will be in my hands on tuesday:nod:

Pm sent

just had a few runs with these cheap power systems yesterday, a Bullistorm 60a esc/SP 9.5R ultra sportsman v2 motor in a Team C mid 2wd buggy and a 120a grey cased esc/SP 9.5R comp 2 motor in a Team C rear motor 2wd buggy. both of these ESCs came loaded with a older version of HW's stock firmware with turbo boost timings etc. i loaded in HW's current V3 930 mod firmware into them before going for the tests, both ESCs perform alright, power delviery is actually quite linear, two thumbs up.

the Bullistorm 60a esc seems more nicely made, with proper solder posts for those main power wires (skinny 14awg). for this particular esc, just need to remember to reverse the polarity for the heatsink fan plug.

the 120a esc however didnt have those pictured plug-in posts soldered at the wiring terminals, instead skinny 14awg wires are directly soldered to the pcbs. but no major hiccups here, just need to swap in whatever guage wirings that is required.

Hey 2wd have you picked up one of those dualskys yet? Thoughts?

No, but I am definitely going to..Once I saw how the programming was layed out in the manual it didnt take but a second to see that is VERY hobbywing-ish as far as how the firmware is set-up for programming it.My curiosity is piqued:nod:I mean is hobby wing making everybody's speedos now except for tekin ,novak,viper and LRP?? Its sure seeming that way..I heard a viscios rumor that the new Orion speedo is actually hobbywing produced, and we already know speed passion is hobbywing produced...so yeah,I have to check out the dual sky!

iv'e just noticed with my yellow esc if my transmitter is switched of while the esc is on the car will take off . can anyone else confirm this is the same with theirs ? cheers