i am very bummed i cant finish my truck until wednesday. i lost a small gasket for the outdrive a part so small holds me back :flaming:

would this digital caliper work for getting my front and rear turnbuckles the correct length that they need to be?

http://www.ebay.com/itm/6-INCH-ELECT...item256f84bf12

Yes. however the printouts in the manual are actual size so that could work in a pinch.

is there a digital caliper that is made for rc that will work alot better?

Nope!

so this digital caliper will work very good then?

http://www.ebay.com/itm/6-INCH-ELECT...item256f84bf12

the blue factory team screw set that came in the box with my new sc10 4x4 factory team are they for the chassis etc to dress it up a little better?

Check your instruction manual , shows where the blue screws are used .

ok thank you.

RTFM!!!
Sorry just had to :lol:

So AE includes a book with this 1000 piece puzzle that I should read before I ask questions? Waaaaaaaa??:ha:


BTW, has anyone counted exactly how many individual pieces in this kit? I am looking in the book now! First one to get right answer wins a prize.

Over 250 screws and a lot of plastic parts.

3 pieces

I think I found my motor mount issue. The plate was worn were the screws were so even tightened all the way down I could move it by hand. I added some washers and now I can't move it. Will this hold up or should I get a new motor plate?

so today im getting the truck ready for tomorrows racing . doing a little work to set up and what not and thats the time you always find something wrong.

the lip on the back of the axle hexes wore off,i should say melted off. completely on one. im not sure how this happened. one of two possible ways. one i easily over tightened the wheel or 2nd it was cause my wheels were wobbling from to much sand in the tires (fixed that problem).

so hopefully the hobby shop has them in stock.