idrummerboy13

iTrader: (15)

run moldeds

T-BirdJunkie

iTrader: (10)

That's great for indoor.

Kraig

iTrader: (81)

I am going to say yes, out by the wheel on the steering knuckle.

B.A. Racer

iTrader: (10)

ok i did the hex and the rears work perfectly fine...but when i tighten the fronts down they bind and dont move..the wheel sticks..even if the nut if only 1 turn on you can feel it binding..they arent associated wheels but it doesnt seem like the whell is it..and the bearings are brand new

brent701

iTrader: (8)

what parts dd you replace to add the hex and which hex?

B.A. Racer

iTrader: (10)

b4 wheel hex axles 7496 the steering block 9880 and im just using associated plastic hexes right now just cuz i got them for free at the shop

big chris

iTrader: (51)

I also have a hex conversion question. Will my RB5 wheels fronts and rears work? Amain says 22 compatible wheels?

And its just these parts for the F/R conversion right?

ASC 7496,7497,9880

brent701

iTrader: (8)

What rims? I have found some rims you can't tighten the axle nut all the way down it will bind the bearings. I am not sure which ones they were though. I used a set from a buddy at the track and they did this to my buggy as well in the front

Yes, also add #4449. They are the nuts that hold the ball stud to the RS steering blocks. They don't just screw into the blocks.

You can also use Jconcepts 2091 for the rear only.

B.A. Racer

iTrader: (10)

they are older team C rims..yea that is the only thing i can think of right now.

SkarTisu

iTrader: (8)

Do you have a shim between the axle pin and the outer bearing in the hub?

B.A. Racer

iTrader: (10)

yes i do

deftones4012

iTrader: (19)

Did you use the "C" clip between the bearings? I believe it acts like a crush tube in the rear hub.

Zach Phillips

iTrader: (16)

They are the best open cell foams I have ever tried. Always consistant package to package and last a really long time. Amain has them listed to be back in stock on the 22

I also learned when running the plastic hexes on the RB5 If you tighten the front wheels down to hard it would bind. Same problem with the plastic B4.1 hexes/ Fixed that when I switched to aluminum clamp hexes.

Timmahhh

iTrader: (15)

I thought I'd post up a couple pictures of the new finnisher.

Teambcw

iTrader: (28)

they will be available soon... many things are back ordered right now from all manufactures. I spoke to them 2 days ago and they are cutting and packaging foam as we speak... should be in stores in a week... I know this foam works way better then molded at my local indoor track.