Did you strip the screws or the adapter?

Screws

Your answer is probably a hundred pages back. The issue was covered. I cant remember the size but it is metric. I remember a tip was to use a longer screw (6mm) to avoid stripage issues. Do a search. Best guess for the size is m2.

Well not really, it all depends on the track. I have seem some people run 2 washers and i have also seen people use none. I find that 1mm washer gives the car too much push.

Has anyone had an issue with the alum hubs having slop bearing holder? My bearings seem a little loose in the hub

M2X6MM

These work perfect!

http://www.ebay.com/itm/270962182138...84.m1439.l2649

All my hubs have slop in em too bro and idk what to do

I am looking for a non cab foreward body for a +8 worlds car, any ideas?

I use a 1/8 inch strip of packing tape across the outer bearing, tightens up the slop! I also set screw all my hinge pins.

You can use any body, it will just have a little space by the front shock towers. This one is a +8 and is not too cab forward.

http://www.amainhobbies.com/product_...-65-Rear-Wings

Ok thanks, is that where the +8mm is ?

double post

Yeah, its hell trying to set camber. It moves like 1-2 deg. I almost wanna put the plastic hubs back on, because they were tight.

I agree, I hate the cab forward look.

Yeah, the punisher does not look too bad.