Durango DEX210 Thread
Thats sick, i like it!!
Tech Fanatic
iTrader: (6)
Tech Fanatic
iTrader: (29)
19mm front 18.5mm rear I run on carpet.
Guys I have one set of skids left over from this batch. They are the front and larger rear for the dimec chassis. Pm me for details Thanks....
I've been racing all year having good luck with a B4. Last night I ran my mid motor Durango for the first time. It would fly through the air and have a tendency to tilt left or right in the air making it very challenging to land flat. Is there anything setup or drive train related that would cause this.
R/C Tech Elite Member
iTrader: (520)
New shell installed and ready to go....
Attachment 1033194Attachment 1033195
I also have a couple rollers for sale if you know of anyone looking for a 210..
Attachment 1033194Attachment 1033195
I also have a couple rollers for sale if you know of anyone looking for a 210..
Tech Regular
iTrader: (8)
lol was a guess on the longer looking shock springs jorn was using, but could be a lower rear cf tower. The fronts look long also to me unless there just ALOT stiffer than any of the ones I have. Then again I am using Losi springs since there readily avail to me at the track..
My ride height is around 21-23.
My ride height is around 21-23.
Tech Elite
iTrader: (40)
I broke a front hub carrier, and of course everyone is out. Is there any place to buy aftermarket aluminum ones?
Tech Regular
iTrader: (1)
Tech Master
iTrader: (4)
Tech Elite
iTrader: (40)
Contact Potoczak, they were looking for interest in c-hubs for the 210 range http://www.rctech.net/forum/electric...l#post11793405
Tech Master
iTrader: (4)
Tech Elite
iTrader: (10)
tower had the c hubs for a few days before they were out of stock, if you ordered them from your LHS you might get them very soon, I should be getting a pack as spares tomorrow if the order shows up