Hyper 7 laydown servo conversion setup
#1
Hyper 7 laydown servo conversion setup
Hello,
I have been searching for the Hyper 7 laydown servo configuration guide and/or diagram or something. Does anyone know were I can find this information? Please don't tell me, ONFA manuals webpage. Because I have searched long and hard for it there, also used their forums as well. No luck.
I have a Hyper 7 PBS.
Thanks for your time
I have been searching for the Hyper 7 laydown servo configuration guide and/or diagram or something. Does anyone know were I can find this information? Please don't tell me, ONFA manuals webpage. Because I have searched long and hard for it there, also used their forums as well. No luck.
I have a Hyper 7 PBS.
Thanks for your time
#3
Tech Addict
iTrader: (4)
I have one installed in my roller. If you need photos let me know.
BTW, the manual was on Ofna's website all the way at the bottom on the manuals page under the Miscellaneous Manuals & Instruction Sheet section.
http://ofna.com/pdf/PCRservos.pdf
BTW, the manual was on Ofna's website all the way at the bottom on the manuals page under the Miscellaneous Manuals & Instruction Sheet section.
http://ofna.com/pdf/PCRservos.pdf
Last edited by pumpkinfish; 05-02-2007 at 06:51 PM.
#4
Originally Posted by pumpkinfish
I have one installed in my roller. If you need photos let me know.
BTW, the manual was on Ofna's website all the way at the bottom on the manuals page under the Miscellaneous Manuals & Instruction Sheet section.
http://ofna.com/pdf/PCRservos.pdf
BTW, the manual was on Ofna's website all the way at the bottom on the manuals page under the Miscellaneous Manuals & Instruction Sheet section.
http://ofna.com/pdf/PCRservos.pdf
Ugly cat, BUT GOOD MAN!!! THANKS.
I am a dumbass for not see that. But, I now have the question about do I have a PBS or PCR hyper 7???
But thanks.
#6
Tech Regular
iTrader: (3)
CHECK THIS SITE. This is where you get the laydown servos kit plus the pivot ball suspension system etc
http://www.rcmart.com/catalog/defaul...id=121&&page=7
satisfied?
LONG LIVE Hyper 7
http://www.rcmart.com/catalog/defaul...id=121&&page=7
satisfied?
LONG LIVE Hyper 7