JConcepts Thread
#4741
Not at the moment, but the new Pressure Points have doing well in those conditions. We also have something else already in the works for SC....Stay tuned .
#4742
since you guys answer here more then the other thread
will there be a 1/8th finsher for the serpent?
will there be a 1/8th finsher for the serpent?
#4743
Depends on the pattern; DD's and Bar Codes have great wear. Pressure Points wear much faster at Bashers.
#4744
#4745
#4747
ide like to see a cab forward or "bulldog" style Short Course body. . function over form. . . . possible?
#4750
Tech Elite
iTrader: (15)
what surface would those be good for? Topsoil/clay that slowly builds up a dusty layer?
in summer i run a y bar like tire and switch to a double dee/holeshot tire when conditions get dusty, the pin tires rip when the surface is swept and they cause over traction and that is what rips the dirt, i hope this tire could work for me.
Jconcepts your tires are great! Idk but are the molded inserts softer now? the old ones were to stiff. Currently use a proline foam in these. wish i could keep the same company on the cell lol
in summer i run a y bar like tire and switch to a double dee/holeshot tire when conditions get dusty, the pin tires rip when the surface is swept and they cause over traction and that is what rips the dirt, i hope this tire could work for me.
Jconcepts your tires are great! Idk but are the molded inserts softer now? the old ones were to stiff. Currently use a proline foam in these. wish i could keep the same company on the cell lol
#4751
Tech Master
iTrader: (10)
would you please list the 12mm hex,short course rims in order of their offset and list the offset? This would also be a great tool for your website so people that have a set of your rims would know what would happen to their width if they were to try a different rim offset.
#4754
Tech Elite
iTrader: (89)