Just throwing this out there lol.....LOVE JCONCEPTS PRODUCTS, got the stickers all over everything hahaha even on my truck and sunglasses heehee

As long as you understand ;p

Get that MBX7 eco body finished first, the rest can wait

It's done and doing photos now for the press release

So I think I've seen the question asked before but does anyone have a photo of the Medium Roller Bag loaded up? I'm looking for gear transport, I've got my buggies and radio covered but need something to carry my tools, charger setup and spares. Right now I'm using a duffel bag and then carry my tools box (Plano tackle box). I was looking at the Ogio 9800 but that thing is SO big...the size of the JCon bag looks better but I do wonder a bit about the build quality.

Who's got experience and does anyone have a photo? I've got no LHS so this would be an online order and thusly I can't see one in person.

I posted this a few months back; this is from one of our Team Drivers Lila Flinn.

Stuff Daimon in a bag to show how capable it is, he will EASILY fit into a JC medium bag.

Oh man, guess I getter get that airbrush warmed up then

Just got the hi flow 0222 and got it all painted up and drywall tape and shoe goo. Looks GREAT!!! Now the question, I can clearly see the 4 hole locations in front and 3 in back but I have a 22 SCT and it is not listed in the diagram that comes with the body and now that the tape and goo is in there, well its hard to figure exactly where to punch the holes. Any of the premarked holes work? Sorry for the novel from a newby, but dont wanna screw this up. Any input is greatly appreciated.
Kris

Can't help with where since I don't have a 22, maybe someone in this thread knows and if not ask in the 22 SCT thread. For sure someone there will know.

For the next time though, mark where your holes should be on the over spray film before you paint. Much easier to line it up while its clear and unpainted.

You can try putting a dab of grease on the top of the posts and place the body to mark where you should ream. It won't be perfect, measure to square up your holes.

I have the J C 3 drawer bag and it works really good love it. Had it for a good while and it's holding up really good. Got my 10th scale buggy in it tires tool batteries and ect.

For the rear of the body; the holes are the ones closest to the roll-bar, there should be a notch in the roll-bar for the holes.

For the front; I will have to wait till I get to work tomorrow to confirm, but it is marked.

Just hold off and I will confirm tomorrow.

I have two of medium non roller. They hold a lot of stuff, build is decent. I used servo tape instead of stock tape included. I prefer a roller from Racers Edge but JC is good bag for extra cars and RC items that always stack up.

So I just got some green Bro Codes and I'm wondering why one of the sidewall sides is shiny and the other side is dull? I noticed they are directional and the shiny side is opposite. One tire is shiny on the outside and the other is shiny on the inside. Is this a big deal?
Blake

Added the picture for reference.