MUGEN SEIKI MRX5
#2177
hi, just quick question looking for size of weight C.. wanted to adopt it to my nt1. Thanks!
#2178
Tech Rookie
H2202 rear pully 48t
#2179
I know from reading this thread regularly that many of you have had the same problem that I have with the front upright ball cup, that connects to the front upper arm by the 18mm tie rod, breaking on easy impacts or even simple taps on a wall from a wide turn. I also have read that Mugen or someone had an improved upper arm product at the Worlds in April, but I have yet to see anything offered for sale. This has been the only weak spot that I have found on the MRX5. Otherwise I have been very happy with the new design. So my question is, does anyone know of anywhere that you can order the "Ball Cup" as a part bag without ordering the whole arm package? I did find part #H0136 (MRX4R) and H0136B (MRX4X) front upper arm sets.
Thanks in advance for your input,
Roger
Thanks in advance for your input,
Roger
#2181
#2183
nobody knows sizes of cylinder 20g weights?
#2184
Tech Addict
I know from reading this thread regularly that many of you have had the same problem that I have with the front upright ball cup, that connects to the front upper arm by the 18mm tie rod, breaking on easy impacts or even simple taps on a wall from a wide turn. I also have read that Mugen or someone had an improved upper arm product at the Worlds in April, but I have yet to see anything offered for sale. This has been the only weak spot that I have found on the MRX5. Otherwise I have been very happy with the new design. So my question is, does anyone know of anywhere that you can order the "Ball Cup" as a part bag without ordering the whole arm package? I did find part #H0136 (MRX4R) and H0136B (MRX4X) front upper arm sets.
Thanks in advance for your input,
Roger
Thanks in advance for your input,
Roger
#2185
#2187
contact Billy Bowerman up at SpeedWorld Raceway in Roseville,Ca. for J&S arms. That's where I got mine and I straight paaaaalowed the boards off the sweeper with no damage to the arms or aluminum rod ends at all. These arms are VERY strong.
#2189
Tech Adept
#2190
Thanks a million! Unfortunately they are too high for my NT1. Will have to figure something else, but thanks again!