bobbyblaze

iTrader: (1)

yeah i order the rear towers last night all i need to order some shocks and a fuel tank 150cc

brc358

iTrader: (18)

Bobby
Are you ordering the new shocks for the stand up shock mod I sent you?
If so, you dont need new shocks. You use the same original front shocks, but only change the shock tower

bobbyblaze

iTrader: (1)

ok cool ....man alot of ppl asking for the set up lol

bigjez

Lol it ok ill figure one out bro can't give all the house secrets out lmbo.

rageworks

iTrader: (47)

I just wanted to let everyone know that Nitrohouse is
having a ,10% off everything, Fathers Day Sale.
I just ordered a bunch of goodies for my BCE PJX-DM1
project. Also some spares for my Pro and Spec cars.
The discount code is on the Nitrohouse home page,
"father2010" .
You can buy the JL .21 engine for under $158 today.
The JL.21 and a JP3 pipe is a screamin combo
in a DM-1.

bobbyblaze

iTrader: (1)

have you guys try the setup? tell me the outcome

casterdriver

Got a question........... finally got my DM-1S running and was blasting up and down my street putting a tune on a motor for its first race this weekend........ the stock brake disk is already starting to round out the center around the outdrive. What steel brake setup will go on it?

bobbyblaze

iTrader: (1)

go to nitrohouse.com click on dm-1 then click on hop-ups has everything you need

snrscion

iTrader: (21)

Yeah Nitrohouse will have everything you need.

snrscion

iTrader: (21)

I made some new towers for the DM1. What do you guys think.





if anybody want some let me know.

Scott Kerkes

iTrader: (83)

Very Nice SNR does it again.

bobbyblaze

iTrader: (1)

nice job .....can you pm me a price & do you make the servo tray?

rageworks

iTrader: (47)

Has anyone else had problems with there front upper
control arms? I have replaced the arms and shafts on
both of my DM-1's and the brand new ones have quite
a bit of slop in them too. I also replaced the arm holder
inserts and the upper piviot-ball end of the arm still has
alot of free lateral movement. I'm considering making some
larger diameter arm shafts out of drill-bit stock and reaming
the arm holes and inserts to fit better.

bobbyblaze

iTrader: (1)

so far i have no problems

rageworks

iTrader: (47)

?????