Minami

iTrader: (5)

is the center one-way for the TB03 already out on the market?

DA_cookie_monst

iTrader: (1)

anybody got a setup for 10.5 yet, one that gets rid of the terrible torque steer?

swatdoc

swimbikerun - you have to flip them over and run either 3mm or 4mm spacers under them (depending if you use the stock 1mm shims or not) to space them to the correct height. Or get the new bridged mounts made by 3racing

I just received a couple of spur gears made by PRS as suggested on this thread. the quality is fine, but I have 2 problems with them - the first is that they are only 1/2 the width of the stock gears. The second and worst is that only 2 of the holes lineup with the mounting holes on the spur adapter - not all 4 like stock. not real comfortable mounting thespur with only 2 screws.

Does anyone know if the Robinson or some other brand spur actually mounts correctly before I waste my money again?

DA_cookie_monst

iTrader: (1)

I use RW spurs, and they are less than half thickness and mount with two screws, if they are good quality, they will be far better than the Tamiya ones.

swatdoc

OK well thanks cookie - if you're using it that way with no problems I guess i'll give it a try!

Minami

iTrader: (5)

no probs on the screws, my tamiya spur on my TA05 also uses just 2 screws.

swimbikerun

iTrader: (108)

I just used the PRS 72t 64p spur and it worked great. 2 holes works fine, especially for 17.5.

Thanks for the suspension bridge. I flipped the bridges for the ones away from the front/rear with only 2mm of spacers and ran the bridges clostest to the front/rear flat with 0 spacers. This seems to drop the roll center down.

TXwasabixx1

anyone know wat all i need to do a ifs conversion on a TB03D??? AND is the drift version normal front suspension ok for racing??

DA_cookie_monst

iTrader: (1)

the upright front shocks are fine dude

Hebiki

iTrader: (26)

where can i get a blank set up sheet for the TB-03?

DA_cookie_monst

iTrader: (1)

I want a 19t/10.5 setup, that mostly gets rid off the dreaded torque steer

Hebiki

iTrader: (26)

my guess would be the top front bulkhead and front shock tower.

swimbikerun

iTrader: (108)

PM me your email and I'll send you a .pdf in the morning.

Minami

iTrader: (5)

i wish there would be an R version for this....

TryHard

iTrader: (4)

YGPM