BMI's DB12R
#6091
Thats a good idea. The only problem would be that the battery has bumps on the bottom of the pack so you would have to shave them off.
#6092
True, but I think the lipo pack can be flipped upside down or the plate can be machined to accept the bumps (I'm sure Jason can use one of his fancy milling machines )
#6093
#6096
Tech Champion
iTrader: (31)
So since the 10-degree block gives the most 'static caster reduction', that must be the reason it's so aggressive/twitchy on initial turn-in?
And the shims affect 'reative caster'? Both shims in rearmost position, 6-degrees, both sides of block/ 4-degrees and in the foremost position, 2-degrees?
Don't flame me if my thinkin' is slowwww
And the shims affect 'reative caster'? Both shims in rearmost position, 6-degrees, both sides of block/ 4-degrees and in the foremost position, 2-degrees?
Don't flame me if my thinkin' is slowwww
#6097
Tech Elite
iTrader: (64)
Join Date: Jun 2008
Location: Conducting aggressive board meetings at my local track
Posts: 3,301
Trader Rating: 64 (100%+)
So since the 10-degree block gives the most 'static caster reduction', that must be the reason it's so aggressive/twitchy on initial turn-in?
And the shims affect 'reative caster'? Both shims in rearmost position, 6-degrees, both sides of block/ 4-degrees and in the foremost position, 2-degrees?
Don't flame me if my thinkin' is slowwww
And the shims affect 'reative caster'? Both shims in rearmost position, 6-degrees, both sides of block/ 4-degrees and in the foremost position, 2-degrees?
Don't flame me if my thinkin' is slowwww
http://aedownloads.com/downloads/man...2l3_manual.pdf
Go to page 16. I hope this helps.
#6098
Tech Champion
So since the 10-degree block gives the most 'static caster reduction', that must be the reason it's so aggressive/twitchy on initial turn-in?
And the shims affect 'reative caster'? Both shims in rearmost position, 6-degrees, both sides of block/ 4-degrees and in the foremost position, 2-degrees?
Don't flame me if my thinkin' is slowwww
And the shims affect 'reative caster'? Both shims in rearmost position, 6-degrees, both sides of block/ 4-degrees and in the foremost position, 2-degrees?
Don't flame me if my thinkin' is slowwww
#6100
Tech Champion
Car ran great today...driver could use some help Managed to finish 3rd out of 4 drivers but was catching up to the leaders several times. Ended up changing where I stand while driving and haven't gotten used to it yet...once I do I'll be fast again
#6103
Hey Jason, wondering if the pre-orders for the upgrade ready to be shipped out....ready with my payment.