Serpent 966
#2192
#2193
Tech Adept
Hi people,
I am currently running the front hubs with larger bearings, is this ok? If I was to use the small bearings with eccentric housings what position should I run them in and what effect would it give? Also, with regard to the hubs being marked 1 and 2, I am using No1 on the right. What effect does it have if I were to swap them.
Thanks in advance
I am currently running the front hubs with larger bearings, is this ok? If I was to use the small bearings with eccentric housings what position should I run them in and what effect would it give? Also, with regard to the hubs being marked 1 and 2, I am using No1 on the right. What effect does it have if I were to swap them.
Thanks in advance
#2194
Hi people,
I am currently running the front hubs with larger bearings, is this ok? If I was to use the small bearings with eccentric housings what position should I run them in and what effect would it give? Also, with regard to the hubs being marked 1 and 2, I am using No1 on the right. What effect does it have if I were to swap them.
Thanks in advance
I am currently running the front hubs with larger bearings, is this ok? If I was to use the small bearings with eccentric housings what position should I run them in and what effect would it give? Also, with regard to the hubs being marked 1 and 2, I am using No1 on the right. What effect does it have if I were to swap them.
Thanks in advance
I don't see any problem in running bigger bearings, just more mass to turn around but more solid and long lasting than the small original ones. Many pro racers do that. Just make sure your belt is not too loose or too tight.
Regarding the eccentric position, they only adjust the belt tension that's it because they put the inner axle forth or back.
I have heard so many tech theories about the position of the eccentric but honestly I believe they just strach or loose the belt nothing else. The position of the front wheels will not change with the eccentric carrying the one way, unless we are talking about the wheel hub eccentric.
1 and 2 stands for left and right but in this case I think you are talking about the whell hub right?
#2195
Tech Adept
Thanks for your reply sm4100.
I was referring to the eccentric adjusters when using the small front hub bearings.
I have never experimented with them so was wondering what effect it has on the handling.
Sorry for any confusion.
I was referring to the eccentric adjusters when using the small front hub bearings.
I have never experimented with them so was wondering what effect it has on the handling.
Sorry for any confusion.
#2197
I am looking for used 966īs in good condition (in both nitro and E).
Rollers or complete.
Send a PM
Rollers or complete.
Send a PM
#2199
go for 18-20mm
#2200
#2201
Can someone tell me the part number for the long rod ends like for use with rear suspension extension kit. The hard ones that has the word:top on the one side.
#2205
EVO-Workshop 966 7075 T6 Hardcoated Chassis (EVO-966-ESE903323)