qtop

Hey Guys,

I am looking for a setup for high speed drifting.(Corally Assasin) Using a 60a xerun xtreme stock with a Xerun 17.5t motor.
Also what would be the best software?
Tires on car are HPI Type A Super drift.

Just ordered a LRP X20 8.5T for new setup.

Thanks,
Quito

puma303

sameone cna help me to find a good setup?
my car is a hot bodies tcx, motor is a lipotech xr 10.5T and the esc is the 120A V 2.1

PhilipT32011

Hello guys! I have a hobbywing V2.1. I use this speedo since 2011 and i had not any problem since yesterday race... when i give full throtle on the track's straight the car gets in brakes. if i push the trigger veeery smoothly the car accelerates. Has anyone any idea what is going on? Thanks in advance

MWarren

Hi, slightly off topic but thought this would be the best place to ask. I need a sensor board for a xerun 13.5t motor. Does anyone know where or if its possible to get one. Preferably in the UK. Thanks :-)

COBRARACING

please contact chris at cpd racing uk

ScottyTC4NZ

Bump

chris_dono

As Angelo says, please get in touch

[email protected] is the address to send to.

Cheers
Chris

MWarren

My mate has done the above. CPD are taking a board from a new motor and sending it to him. Now that's what I call service. Top bloke cheers.

chris_dono

Glad to be able to help

tcboy1983

i run the hobbywing v3 with a gm2012 13.5t at the aldershot uk track
this is my setup if it helps

General settings
profile 6
running mode forward/brake
voltage cutoff disabled
esc over heat protection 125deg c
motor over heat protection 125deg c

throttle control
puch rate switch point 50%
1st stage punch 30
2nd stage punch 30
th input curve linear

brake control
drag brake 0%
brake strength 87.5%
initial brake = drage brake
brake rate switch point
1st stage brake rate 20
2nd stage brake rate 20
brake input curve linear

Boost
boost timing 42deg
boost start rmp 1500
boost end rpm 17500
boost slope linear
boost controlled by th yes

turbo
turbo timing 22
turbo activation method full th
turbo th delay 0.2s
turbo start rpm 19000
turbo engage slope 24deg/0.1s
turbo disengage slope 18deg/0.1s

if u have less infield and lots of big straights try adjusting up to 10deg of timing off the boost to the turbo

the esc runs about 46 deg c (with fan)
motor coming off 68-74deg c
the weather temp was around 20deg c

fdr 6.25-6.40

let me know if its good or if anyone else has a good 13.5t setup for a v3

bpalmer

iTrader: (1)

I am putting together a new 12th scale and would like to try a hobbywing esc. will be running 17.5 blinky and possibly mod at a later date. What esc would you reccomend ? 60 amp ? i do not want to run an extra receiver battery or a booster. Also do i need a program box ?

ByteStream

iTrader: (2)

Xerun-120A-1S - designed for 1S use, no need for a booster or rx pack and can handle mod just fine.

Yes to the program box.

bpalmer

iTrader: (1)

THANK YOU...almost ordered the wrong one....appreciate your input !

COBRARACING

thanks chris Cpd is your main source for the uk for hobbywing and pro amps especially for the racers

vitomon

is there any website were v3 settings are collected?