Mugen MBX5R
#1006
Tech Adept
iTrader: (6)
I am still working on my setup, so cannot speak directly to your question.
Nevertheless, attached please find the stock setup sheet that might help you.
Also, in the thread below a complete setup got posted: Good luck,
Frank
Last edited by Starter box; 04-18-2008 at 01:55 PM.
#1007
has anybody tried any other manufacturers wheel hubs/nuts for the mugen? Over the past 3 years with (2 years Prospec, 1 year so far w/R) i have probably gone through 3 sets (12 total) of hubs due to the nuts' threads getting f'd up due to various "things"... and had to use brute force and GM penetrating oil just to back the nut off (while destroying both the hub and nut).
I would not be adverse to Losi either (LOL) if they fit
I would not be adverse to Losi either (LOL) if they fit
#1008
#1009
here they are on my buggy
**edit.....let me get a better pic
**edit.....let me get a better pic
#1010
#1011
#1012
Thanks starter box but i have these...
can you tell me how much droop do you use?ride height?
can you tell me how much droop do you use?ride height?
#1013
Thanks imaxx...i notice you have a washer behind the hub...do they not have the "step" that the stockers have? or are you taking up some slop....
#1014
thats not a washer, the hubs are flanged..
so are the nuts
so are the nuts
#1015
got it...i saw the nut flange, guess i shouldve figured..lol must be the wobbly pops. mmmm Red Stripe
#1016
should be 104mm in front and 128.5 in the rear
measure from the top screw to the bottom screw (center to center)
make sense?
ride height: bones level in front and bones slightly above level in the rear
#1017
i cant do this because i have eight's shocks...can you give me please the distance from the ground-hub?like the manual!
#1018
are you serious? no wonder you're having set up problems....
#1019
#1020
16mm front
rear my arms pretty much touch the table
rear my arms pretty much touch the table