Tamiya TRF417
#5236
Hey guys looking for a starting setup for my local track with a 417 v5?? Here is a video of a qualifying round. http://m.youtube.com/index?&desktop_...feature=relmfu
We run 17.5 blinky and our tire choices are Solaris hard or jaco blues. Also typlicly the traction is medium to high sometimes a little lower then medium. Thanks for any help.
We run 17.5 blinky and our tire choices are Solaris hard or jaco blues. Also typlicly the traction is medium to high sometimes a little lower then medium. Thanks for any help.
#5237
Tech Adept
this might be a silly question, but here goes
the chassis fans people mount behind the motor... are they aimed at the motor blowing air on it, or away from it, pulling air off it?
the chassis fans people mount behind the motor... are they aimed at the motor blowing air on it, or away from it, pulling air off it?
#5240
i ran a 94t yeah racing spur but i preferred the kawada 97t spur, both fit without drilling new holes. Ran them in 17.5t blinky
#5243
http://rcmarket.com.hk/product_info....b9d516bd82110c
#5244
Tech Champion
iTrader: (94)
You can use these which are 0.5 mm and usually the norm or the 1mm ones or 0.5 mm shims need 2 per block and they are the silver tamiya ones .?
http://rcmarket.com.hk/product_info....b9d516bd82110c
http://rcmarket.com.hk/product_info....b9d516bd82110c
#5245
#5246
can you share the insight , Narcotiks ?
#5247
Tech Champion
iTrader: (94)
Today I was at WCRC with my 416WE and was reviewing Jilles' set ups for high traction, and on all sheets he was using a 1 mm spacer on both inner and outer rear mounts. Back then they didn't run separate mounts, so I started my research.
#5248
Hi, need a pinion to fit the 417 v5. the kit comes with 111t and 113t spur, but im not familiar with the pitch? 0.4? as i am coming from a X-ray t3. Will be running a 17.5 motor
Which tooth size pinion & brand for a mid size carpet track?
Also should i use the 111t or 113t spur?
Thanks
Which tooth size pinion & brand for a mid size carpet track?
Also should i use the 111t or 113t spur?
Thanks
Last edited by rayrush; 05-08-2013 at 03:05 AM.
#5249
Tech Regular
kit spurs are 64dp.
#5250
Thanks, so i need 64dp pinion,
What ratio or tooth size should i be looking at for mid size carpet using 17.5 motor?
111t or 113t spur?
What ratio or tooth size should i be looking at for mid size carpet using 17.5 motor?
111t or 113t spur?