MUGEN SEIKI MRX5
#781
#782
#783
You can also save the file to your hard drive for faster load and to have on hand.
\
----->
Mugen MRX4X - Novarossi
#785
hey just just alittle tip rear lower arm holder b the top screws above the plastic inserts that hold the lower arm pins in use a 1mm shimm not a thrust bearing shim find a shim with a 3mm hole so it fits right onto the sig3x6 screw but is larger then the button head this will insure the plastic caps do not vibrate loose and cause the lower pins to come loose.....
#786
What are the steering rod mm for the MRX5 are they 57mm?
Oh I can not download the manual so can someone help please Thanks,
Oh I can not download the manual so can someone help please Thanks,
#787
85.8 on the steering rod on the servo saver rod its 39 just go to adobe its free to download the adobe reader... important to have
#788
The file is in PDF format make sure you have Adobe reader if you do not go to http://get.adobe.com/reader/ and install it you then should be able to read it.
You can also save the file to your hard drive for faster load and to have on hand.
\
----->
Mugen MRX4X - Novarossi
You can also save the file to your hard drive for faster load and to have on hand.
\
----->
Mugen MRX4X - Novarossi
#789
No your info is not correct 85.8mm is from ball-end to ball-end. What is the mm on the rod only? also the manual does not tell me what are the pulley teeth on the rear are. Not the rear axle
#793
MRX-5 Gets Results
Florida State Series Race number 2 in Fort Myers, FL.
The first outing for many with the new car. I ran my fastest qualifier ever.
6 out of the 10 A Main cars were MRX-5.
1 MRX-4X
3 other cars
Attached is the podium photo and a some of the Mugen racers at the race.
Monday night goto forgass.com for results and photos.
The first outing for many with the new car. I ran my fastest qualifier ever.
6 out of the 10 A Main cars were MRX-5.
1 MRX-4X
3 other cars
Attached is the podium photo and a some of the Mugen racers at the race.
Monday night goto forgass.com for results and photos.
#794
MRX5
We have the brass battery tray in stock now. I will add it to the website tomorrow. We will have the Billet Delrin front body mount by the end of the week and more to follow.
#795
Tech Master
iTrader: (1)
It was over 90 degs. today at the track. Can,t wait for it to cool off
to see how fast the track gets .next race at Kraceway.
IF YOU ARE THINKING ABOUT GETTING THIS CAR, DON.T WAIT !!!
Order it today.
I tested it today when i had a receiver go bad.
Left pit road wide open into the sweeper wall. Lost the engine,but only broke the lower right a-arm on the car.
If you have ever been to the "FORT" you know about the walls . they don,t move.
Mugen you have a WINNER
to see how fast the track gets .next race at Kraceway.
IF YOU ARE THINKING ABOUT GETTING THIS CAR, DON.T WAIT !!!
Order it today.
I tested it today when i had a receiver go bad.
Left pit road wide open into the sweeper wall. Lost the engine,but only broke the lower right a-arm on the car.
If you have ever been to the "FORT" you know about the walls . they don,t move.
Mugen you have a WINNER