R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 14
1
2
3
11
Last »
Search: Posts Made By: jas1
Showing results 1 to 25 of 328
Search took 0.03 seconds.
Forum: Radio and Electronics
11-22-2014, 04:36 PM
Replies: 13,880
Views: 1,875,741
Posted By jas1

new to hobbywing esc

Been given a set up for my 3.1 esc, but my esc has latest firmware installed, just scrolling through and some parameters are missing on the lcd program firmware, 4a is there but 4b 4c 4d are missing,...
Forum: Electric Off-Road
09-23-2011, 12:12 PM
Replies: 19,920
Views: 2,754,324
Posted By jas1

Here is a post lifted from oOple about the...

Here is a post lifted from oOple about the release date, fingers crossed the wait is nearly over:D



I know a lot of you have questions about when is the exact release date of the DEX210, so...
Forum: Nitro On-Road
08-14-2011, 10:51 AM
Replies: 246
Views: 63,701
Posted By jas1

I had this problem when I first started running...

I had this problem when I first started running the car, it just ended up being the tyres and shell I ran, I started on contact rc and blitz r11 body, borrowed a set of shepherd tyres and a 909 body...
Forum: Electric Off-Road
08-09-2011, 03:15 PM
Replies: 19,920
Views: 2,754,324
Posted By jas1

im sold on the 210, pre ordered mine today:D that...

im sold on the 210, pre ordered mine today:D that footage above was from the oople invernational meeting where hupo tq'ed and won the meeting, and craig collinson, uk durango team driver finished...
Forum: Nitro On-Road
07-04-2011, 05:59 AM
Replies: 1,454
Views: 342,761
Posted By jas1

Found the best place for transponders for me is...

Found the best place for transponders for me is just stuck to the top of the steering servo.
As for the movement in the bellcrank, are you building a 2011 kit with the harder servo saver spring? If...
Forum: Nitro On-Road
05-02-2011, 01:46 AM
Replies: 1,454
Views: 342,761
Posted By jas1

The front droop screws into to alloy bulkheads...

The front droop screws into to alloy bulkheads just add a little threadlock and the fine, the rear droop screws just compress the suspension slightly and you can get to them not too bad.
As for the...
Forum: Electric On-Road
04-30-2011, 06:35 AM
Replies: 1,108
Views: 166,061
Posted By jas1

Is the jumper plug still ok? The little plug you...

Is the jumper plug still ok? The little plug you use instead of a booster/receiver pack. My bd always worked fine with the transponder with no boosters ect!
Forum: Nitro On-Road
04-22-2011, 10:26 AM
Replies: 1,454
Views: 342,761
Posted By jas1

Team Shepherd UK

Congratualations to all of the shepherd guys running at the 2nd round of the UK national championship last weekend.
Tq and A final win for Adam catchpole in 200mm followed by Chris Steele in 3rd...
Forum: Nitro On-Road
04-19-2011, 12:24 PM
Replies: 246
Views: 63,701
Posted By jas1

here you go ...

here you go

http://www.rccar24.de/artikeldet.php?proid=30710&sid=f7b8b5780bb287c0da2a2b8706e51e8b
Forum: Nitro On-Road
04-19-2011, 12:22 PM
Replies: 246
Views: 63,701
Posted By jas1

conversions all ready out, we got 1st batch in uk...

conversions all ready out, we got 1st batch in uk a few weeks back in limited quantities, and 2nd lot be here this week. they are on the shepherd shop site under the options section i think :D
Forum: Nitro On-Road
04-11-2011, 02:10 PM
Replies: 1,390
Views: 283,592
Posted By jas1

interesting watching the times live! hara's...

interesting watching the times live! hara's average is slightly down on the top few but hes about the only top 10 runner doing a fuel stop at 5mins where the rest are having to run 2 stops, all good...
Forum: Nitro On-Road
04-01-2011, 02:20 PM
Replies: 14
Views: 1,816
Posted By jas1

sounds like the clutch to me, could either be a...

sounds like the clutch to me, could either be a bearings gone or the clutch tension nut could of come loose.
Forum: Nitro On-Road
04-01-2011, 01:57 PM
Replies: 1,199
Views: 314,631
Posted By jas1

no bias towards your us drivers to see here then,...

no bias towards your us drivers to see here then, lol
Forum: Nitro On-Road
03-29-2011, 02:13 AM
Replies: 246
Views: 63,701
Posted By jas1

just heard the upgrade kits were shipped friday...

just heard the upgrade kits were shipped friday to our distributor, should be in the uk anytime now, guessing same for you guys over there :D
Forum: Nitro On-Road
03-20-2011, 02:28 PM
Replies: 20
Views: 3,684
Posted By jas1

Yes, they don't engage smoothly like the 2 shoe...

Yes, they don't engage smoothly like the 2 shoe system used now
Forum: Nitro On-Road
03-20-2011, 01:42 PM
Replies: 20
Views: 3,684
Posted By jas1

i forgot how old the yokomo car was, i remember...

i forgot how old the yokomo car was, i remember this type of 2 speed, does it have a roll pin inside the 2 speed gear housing?
anyways the idea of setting is still the same, just install the way the...
Forum: Nitro On-Road
03-19-2011, 02:45 PM
Replies: 20
Views: 3,684
Posted By jas1

if the yokomo is the standard 2 shoe 2 speed then...

if the yokomo is the standard 2 shoe 2 speed then you should have a grub screw at the top and bottom opposite each other, these are for setting the gap for the 2nd gear housing to spin freely!
the...
Forum: Nitro On-Road
03-17-2011, 01:31 PM
Replies: 10
Views: 1,556
Posted By jas1

no mate, got the 1st national the week after, to...

no mate, got the 1st national the week after, to get my pass for going have to stay home this weekend, lol, not under the thumb honest, i just prefer a quiet life at home:D

would of thought more...
Forum: Nitro On-Road
03-16-2011, 04:50 AM
Replies: 10
Views: 1,556
Posted By jas1

Now then Tony, long time no see! Yeah I'm...

Now then Tony, long time no see!

Yeah I'm doing some 220mm this year, at your local in a fortnight down at Cotswolds, if your in the country get ya sen there.
Should be a good year, got some fast...
Forum: Nitro On-Road
03-15-2011, 04:23 PM
Replies: 10
Views: 1,556
Posted By jas1

220mm class is alive n kicking over in the uk,...

220mm class is alive n kicking over in the uk, but the 235 class was always popular over here, much more fun to drive than 200mm touring cars
Forum: Electric On-Road
03-09-2011, 12:19 PM
Replies: 1,108
Views: 166,061
Posted By jas1

I was told there were going to be 5 parameters to...

I was told there were going to be 5 parameters to set, there's lowest rpm for timing to start, highest rpm for timing to finish, amount of timing to be added, then also turbo timing and brakes I...
Forum: Nitro On-Road
03-09-2011, 10:53 AM
Replies: 1,454
Views: 342,761
Posted By jas1

you must be running quite a larger receiver if it...

you must be running quite a larger receiver if it sticking out the bottom of chassis mate, i run futaba which are large compared the the like of ko and spektrum and mine has easily 3-4 mm clearance,...
Forum: Nitro On-Road
03-05-2011, 10:41 AM
Replies: 1,454
Views: 342,761
Posted By jas1

Glad you like it mate! Spoke to Dave the other...

Glad you like it mate! Spoke to Dave the other day n he said he was sending the 1st kit out to someone in London, I guessed it was you:D

Enjoy
Forum: Electric On-Road
03-05-2011, 06:14 AM
Replies: 1,108
Views: 166,061
Posted By jas1

Just spoke with the uk supplier and they have a...

Just spoke with the uk supplier and they have a bd with the v3 software installed for testing, also markus mobers is using v3 at the 12th euros and currently sitting 2nd! so hopefully available...
Forum: Nitro On-Road
02-27-2011, 12:27 PM
Replies: 246
Views: 63,701
Posted By jas1

been talking with the uk distributor today about...

been talking with the uk distributor today about the upgrade kit, not a firm price but is sounding that it will be a really good price for what you get;)

hopefully kits and upgrade kits will be...
Showing results 1 to 25 of 328
 
Page 1 of 14
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.