R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 11
1
2
3
Last »
Search: Posts Made By: Govert
Showing results 1 to 25 of 264
Search took 0.02 seconds.
Forum: Electric On-Road
02-27-2018, 03:14 PM
Replies: 9
Views: 1,783
Posted By Govert

Stupid question: did you calibrate your esc again...

Stupid question: did you calibrate your esc again after firmware update?

Also, I myself prefer to factory reset the esc at least 3 times, just to be sure it is truly resetting...
Forum: Radio and Electronics
12-31-2017, 03:36 PM
Replies: 16
Views: 2,332
Posted By Govert

Try to set channel 2 (throttle) to REVerse signal...

Try to set channel 2 (throttle) to REVerse signal on your transmitter. Or when already in REVerse, set to NORmal direction.
Forum: Electric On-Road
03-06-2017, 04:15 PM
Replies: 8
Views: 2,011
Posted By Govert

Racing Performer fan = WTF fan ;)

Racing Performer fan = WTF fan

;)
Forum: Electric On-Road
02-17-2017, 04:58 AM
Replies: 1,833
Views: 410,013
Posted By Govert

Also the case with a carbon chassis :nod:

Also the case with a carbon chassis :nod:
Forum: Radio and Electronics
01-16-2017, 04:45 PM
Replies: 28
Views: 24,403
Posted By Govert

None, other than the specific ones from Sanwa...

None, other than the specific ones from Sanwa itself.

There could be some other brands out there, but for what I know Highest is the only brand.
Forum: Radio and Electronics
01-15-2017, 03:47 AM
Replies: 28
Views: 24,403
Posted By Govert

Yes

Yes
Forum: Radio and Electronics
01-14-2017, 02:40 PM
Replies: 28
Views: 24,403
Posted By Govert

Yes. :nod:

Yes. :nod:
Forum: Electric On-Road
01-03-2017, 09:40 AM
Replies: 8
Views: 764
Posted By Govert

Well yes, for others that were wondering the same...

Well yes, for others that were wondering the same as Trukje. Otherwise people would make the mistake by just buying random wheel hexes and asking themselves why they keep breaking bearings, heating...
Forum: Electric On-Road
01-03-2017, 07:09 AM
Replies: 8
Views: 764
Posted By Govert

Be my guest. Try it out I will say. I have tried...

Be my guest. Try it out I will say. I have tried it out from Tamiya, 3Racing, Yokomo and Hobbyking on my Xray and they did not fit without hassle. But sure, let him try it, no problem.
And...
Forum: Radio and Electronics
01-02-2017, 04:35 AM
Replies: 1,840
Views: 548,049
Posted By Govert

First try to do a hard reset. Connect...

First try to do a hard reset.

Connect battery.
Press and hold SET button.
Switch on esc while still holding SET button.
Release SET button after 1-2 seconds.
Do this 3 times to be sure you...
Forum: Electric On-Road
01-02-2017, 03:57 AM
Replies: 8
Views: 764
Posted By Govert

Not true at all. Most of the above brands have...

Not true at all. Most of the above brands have different cross pin depth in the wheel hex, so you might need to fill the space between wheel hex and bearing with some shims. Or some of the cross pins...
Forum: Radio and Electronics
12-28-2016, 03:43 PM
Replies: 15
Views: 1,838
Posted By Govert

:nod: You can also find the different Hakko...

:nod:

You can also find the different Hakko style tips on Hobbyking.
Forum: Radio and Electronics
12-27-2016, 04:35 PM
Replies: 6
Views: 557
Posted By Govert

Full lipo? Do you have low-voltage cut-off...

Full lipo?

Do you have low-voltage cut-off activated? If yes, what voltage? This might be set to a too high voltage.
Forum: Radio and Electronics
12-27-2016, 03:42 PM
Replies: 6
Views: 557
Posted By Govert

Did you already swap the motor?

Did you already swap the motor?
Forum: Radio and Electronics
12-27-2016, 03:26 PM
Replies: 6
Views: 557
Posted By Govert

Set your throttle and brake end points to 100%....

Set your throttle and brake end points to 100%. Throttle/brake dual rate 100%. Make sure exponential/curve is set to 0%.

After this, calibrate your esc again. If this does not help, set throttle...
Forum: Radio and Electronics
04-12-2016, 12:15 PM
Replies: 18
Views: 11,152
Posted By Govert

RESET the Flow first. Press and hold set button...

RESET the Flow first. Press and hold set button and power up. Release the SET button after 2 seconds. Turn off ESC and calibrate it again.

If that does not help, always change sensor wire and/or...
Forum: Electric On-Road
04-08-2016, 05:23 PM
Replies: 104
Views: 29,346
Posted By Govert

Already shot this in October 2015. They were...

Already shot this in October 2015. They were testing this new prototype in the Netherlands. Looks very fast.

https://www.youtube.com/watch?v=WyTLO9EmGmo
Forum: Electric On-Road
03-22-2016, 04:17 PM
Replies: 748
Views: 172,878
Posted By Govert

Increase rear droop a bit. Droop that is, not...

Increase rear droop a bit. Droop that is, not downstop (lower downstop value).
Forum: Radio and Electronics
03-12-2016, 12:03 PM
Replies: 20
Views: 6,203
Posted By Govert

yes it does. at least the 300W duo does.

yes it does. at least the 300W duo does.
Forum: R/C Items: For Sale/Trade
02-23-2016, 11:24 AM
Replies: 0
Views: 586
Posted By Govert

SOLD Tekin RS PRO esc

SOLD,

Tekin RS PRO. Has been sitting in my spare parts box as a spare. Now willing to sell.

http://i66.tinypic.com/30huf7a.jpg

http://i65.tinypic.com/wji8w0.jpg
...
Forum: R/C Items: For Sale/Trade
02-23-2016, 07:35 AM
Replies: 16
Views: 1,144
Posted By Govert

I've got a Tekin RS Pro for sale..

I've got a Tekin RS Pro for sale..
Forum: R/C Items: Wanted to Buy
02-21-2016, 02:53 PM
Replies: 9
Views: 760
Posted By Govert

Me too. Very good condition.

Me too. Very good condition.
Forum: R/C Items: Wanted to Buy
02-21-2016, 02:49 PM
Replies: 2
Views: 313
Posted By Govert

Me too. Perfect condition, has had very few runs.

Me too. Perfect condition, has had very few runs.
Forum: R/C Items: Wanted to Buy
02-21-2016, 02:44 PM
Replies: 40
Views: 1,720
Posted By Govert

Even though it's located in Europe, but would a...

Even though it's located in Europe, but would a TCXX chassis also fit? Plenty of them available...
Forum: Electric On-Road
02-21-2016, 04:37 AM
Replies: 1,194
Views: 385,669
Posted By Govert

This is a direct quote from me posted in the...

This is a direct quote from me posted in the Tamiya TRF419 thread:


Did you guys ever think of "forcing the suspension blocks to one side"? By that I mean, when you mount a screw in the...
Showing results 1 to 25 of 264
 
Page 1 of 11
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.