Sanwa 92744 Receiver not powering up
#1
Sanwa 92744 Receiver not powering up
Hello everybody,
I just received an M11X with a 92744 receiver which I am trying to install in my Rustler. After I cut the tabs off the leads from the traxxas servos and plug them into the Airtronics receiver, there is no power and does not light up. Am I doing something wrong here? Any help much appreciated.
Thanks,
Joe
I just received an M11X with a 92744 receiver which I am trying to install in my Rustler. After I cut the tabs off the leads from the traxxas servos and plug them into the Airtronics receiver, there is no power and does not light up. Am I doing something wrong here? Any help much appreciated.
Thanks,
Joe
#3
Make sure the signal wire is on inside I'm guessing that it is plugged in backwards also try binding it to your transmitter
#4
Have you gone through the binding process? The Rx won't light until it has been successful bound to the Tx
#5
#6
#8