sparksy

iTrader: (14)

Robbie... What is the deal with the MR12?

People have said its a similer enging to the MT, When I opened my new kit today, I looked at the speck sheet that came with the engine, and it said RS 12 in the table.... as if Mugen just cut and pasted the table onto their bit of paper.....

SHARP

thank you rjl and Cartman!

VenomWorldOrder

suckers! mugen have sold you a dodgy product, they've now left the country!

black-knight

Does the MTX3 come with front and rear sway bars? or are they optional?

VenomWorldOrder

blade front wires type rear. AG placed a NEO blade swaybar on the rear.. works a treat i heard.

oww a quick question. do zero mm ofset rims fit the mtx3?? if so how much more narrow does 0mm ofset make it? 195mm 198mm?? how much?

black-knight

Tamiya offset spacers would be quite handy for use with the MTX3 in this situation. I use the spacers on many of my cars. The spacers come in mutliple widths.

ITEM 53448 (OP448) 4mm Hard Lock-Nut & Spacer Set

Manticore

stock rims are 1mm offset. i.e. track width will be 200mm Vs 198mm

tweakster

What's up Ilaybrik, why are you not working in the 6 inches of snow . Did you get your 3 yet?

tweakster

Ilaybrik, the cuts that Rob makes are they all the same for everyone or does he have different cuts if the money is there?

jason102276

i have one of his engines and he told me he does them all the same even his own i think
i havent finished breakin yet but i looks really fast at 200 and half throttle
everyone i showed it to thought it looked good

tweakster

What's up Jas you need to get back to work and stop playing on the net

YBSLOW

iTrader: (9)

New car is great. Robbie reads this forum and I spoke to him yesterday so if he wants to post the phone number for Mugen customer service here I am sure he will. Robbie I will see ya at TFT!

ilaybrk

twekster all cuts are same the only difrence he spends more time polishing on his and my moters. He just did my siro last sat hour an half it was done but we spent a nother hour after that polishing the back plate and crank. I have one additonal cut on the crank that he didn't do on his.after he was done I started doing A cut on the crank that I like he took the drimel away from me and finished the cut. He told me not to mess up the moter. $60 what a bargin.

SpeedTech

iTrader: (5)

Hi Guys,

We should have most of the new MTX-3 hop-ups from Mugen tomorrow. look for it on our website soon

Thanks,

Steve Wang
Speed Tech R/C
www.speedtechrc.com

ROBBIE C

Here's the number 949-707-5607
please only call if you can't understand something I've might of said on this thread:sweat