Yokomo YRX12
#181
Tech Initiate
Hey Jimmy, I put mine for sale on EBay today.
#182
#184
I have 2 YRX12 that I am looking to sell together or separate. One with Fenix chassis installed and the other with carbon, and a spare Fenix chassis plus misc spare parts.
PM - if interested
PM - if interested
#185
Were you running the Fenix chassis on black carpet?
And if so did you find it was too much flex grip or other issues.
Just curious haven't gotten mine out.. fenix chassis
thx,
Darrald
And if so did you find it was too much flex grip or other issues.
Just curious haven't gotten mine out.. fenix chassis
thx,
Darrald
#186
Tech Initiate
iTrader: (1)
Question: Rear Axles
Question: what rear axles fit the YRX? is there a steel option available?
Reason i ask is i'm finding it difficult to find axles for my kit - I have had one axle split on me (pullethe thread out) so I'm on the hunt for alternatives?
Any help appreciated!
Reason i ask is i'm finding it difficult to find axles for my kit - I have had one axle split on me (pullethe thread out) so I'm on the hunt for alternatives?
Any help appreciated!
#190
Hi all,
Any updates on fitting servos like my 1/12 Savox SH-1250MG that just don't quite fit because Yokomo did not do their homework to space out the mount holes just a bit more? For the bellcrank setup.
Does any of the aftermarket chassis have this addressed or I have to make a custom mount for the front one?
Any updates on fitting servos like my 1/12 Savox SH-1250MG that just don't quite fit because Yokomo did not do their homework to space out the mount holes just a bit more? For the bellcrank setup.
Does any of the aftermarket chassis have this addressed or I have to make a custom mount for the front one?
Last edited by 190mph; 01-28-2017 at 10:53 PM.
#191
Hi all,
Any updates on fitting servos like my 1/12 Savox SH-1250MG that just don't quite fit because Yokomo did not do their homework to space out the mount holes just a bit more? For the bellcrank setup.
Does any of the aftermarket chassis have this addressed or I have to make a custom mount for the front one?
Any updates on fitting servos like my 1/12 Savox SH-1250MG that just don't quite fit because Yokomo did not do their homework to space out the mount holes just a bit more? For the bellcrank setup.
Does any of the aftermarket chassis have this addressed or I have to make a custom mount for the front one?
#192
Or for the price of getting a new chassis, just buy a new servo. hehe
#193
What is the center to center mount hole spacing of the Sanwa SGR-HR? The website I don't think shows all the dimensions of the servo.
#194
I run the Sanwa SGR-HR in my YRX12. It is a direct fit when using the bell-crank steering. But it does not fit when trying to mount it direct servo steering. I guess Yokomo didn't do their homework either when mounting it in that position. haha