YOKOMO Touring Car BD-7
#2881
I'll be there for sure. I just started back racing again and I can see the addiction growing... I'm finally getting this car figured out after a few weeks with it. Hopefully it'll be go to go when you guys show up. Catch ya then!
#2882
Tech Master
iTrader: (14)
Has anyone had issues with the belt tension adjuster cams not lining up symmetrically?
Just building mine up now and it seems that when I line up the adjuster cams in the same position on each side the differential doesn't sit straight in the bulkheads, i.e. not at 90 degrees to the bulkheads. Can't for the life of me figure out what I'm doing wrong?
Any help greatly appreciated, doing my head in
Just building mine up now and it seems that when I line up the adjuster cams in the same position on each side the differential doesn't sit straight in the bulkheads, i.e. not at 90 degrees to the bulkheads. Can't for the life of me figure out what I'm doing wrong?
Any help greatly appreciated, doing my head in
#2883
Tech Regular
You don't have 1 high and 1 low do you?
#2887
#2893
I dunno, something has to be off on the car. My diff lines up straight and you can check that by flipping the car upside down and look at how the diff protrudes from the chassis slot. Are you using the correct bulkheads? There is a left and a right bulk head. The white alignment marks should be on the outsides of the bulkheads. Make sure you don't have two lefts or two rights. Weird, still looks like you have your cams off set. Is your spur on correct? Just looks funny in the pic.
#2895
Tech Adept
is your diff well close properly