Hot Bodies Cyclone
Which one have Hara 2008 Reedy Race & EURO Championship setup sheet ?
Thanks !
Thanks !
Last edited by RC MARKET; 09-16-2008 at 12:29 PM.
couldn't remember where i got it from so i uploaded it to my webspace for a bit.
hara reedy race setup
but be aware i think the invite class was using NO tire additive.
hara reedy race setup
but be aware i think the invite class was using NO tire additive.
couldn't remember where i got it from so i uploaded it to my webspace for a bit.
hara reedy race setup
but be aware i think the invite class was using NO tire additive.
hara reedy race setup
but be aware i think the invite class was using NO tire additive.
Thanks !
This race is use Much More Sweep tire ?
no according to reedy website:
The official handout tire for the 2008 Reedy Race of Champions will be the Sorex 36 mounted on Speedmind rims!
The official handout tire for the 2008 Reedy Race of Champions will be the Sorex 36 mounted on Speedmind rims!
sorry hara was not in the european championships and I also do not have the ETS setup from andernach
Tech Elite
iTrader: (14)
That particular question is going to be an opinion type answer based on driving style. I have my on theory of what should be done but someone else might see things differently. Just about every answer on this thread is based on a racers opinion of what has worked for them....then there are those racers that try to give book answers but have never even tried what they have suggested. No matter what the replies may be to this question just take them for what they're worth and try some of the suggestions you may get and see what works for you.
Good! what your suggestion, then?
Paul
Tech Champion
iTrader: (30)
the rear diffs ones are 10x15x4mm
it uses the same size bearings as the regular cyclone
Tech Regular
iTrader: (3)
Tech Elite
iTrader: (32)
Just an fyi the Losi Eight uses a 10x15x4mm in the clutch bell incase you get in a bind.
On a black edition Cyclone, is it worth getting the 18T center pulleys and different belts, to change the pulley ratio to 2.1666? For USVTA usage.
What usvta combo do you plan on going with? For the 21.5 and 27t options you will be fine with the 16t pulleys. For the 17.5 I would suggest getting the pulleys so you don't need a rlly small spur or rly big pinion
21.5/lipo. I know back in the Xray T1 days, they came out with a different set of diff/center pulleys that lowered the ratio from like 2.22 to 1.77, and it made the cars faster. (Changes in the belt speed and efficiency of the drivetrain) Might have to try it eventually and see if it makes the car faster or not. Also opens up the possibilty of overdriving the front wheels with the front spool
whats the best spur gears to use for 13.5 I need to run at around 4.5 and for 10.5 I need to get to around 5.4
Thanks
Thanks