Hot Bodies TCX
#1487
Tech Regular
iTrader: (10)
#1490
#1491
Does anyone know who has the following in stock? part #68734 Universal Drive Shaft 46mm
#1492
Tech Initiate
Question, which set of arms are the better on impact.
#67719 graphite or #73506 carbon graphite
#67719 graphite or #73506 carbon graphite
#1493
#1494
Tech Adept
hello is the spec-r geardiff already available for the TCX
and where is this vor sale
and where is this vor sale
Last edited by peter.; 12-05-2010 at 02:21 PM.
#1495
Tech Addict
iTrader: (11)
Hi guys I thought Id share my gear diff conversion with everybody. Its a Spec R Xray 38tooth diff giving a 1.9 final drive and no need to change any belts. The diff needs about 1 mm of shimming. Xray 50mm driveshafts and blades. The driveshafts are a perfect fit into the axles. Front pulley is a xray ball diff pulley which has had the centre hole enlarged a little with a body reamer and elongate two holes for the screws.
Thanks for the parts Ant
#1496
Tech Adept
thanx ark but I knew that all I want the original that made especially for the TCX will like to trf416 t3 yokomo
#1497
Tech Elite
iTrader: (11)
http://www.hpieurope.com/piw.php?lang=en&partNo=31420
I was always of the impression the softer high traction arms were more durable.
If you can even get them anymore. Been a while since i played with my cyclone
Not that i ever broke a suspension arm.
#1498
Tech Elite
iTrader: (29)
Hi guys a little more progress on the car. For those of you looking for an alternative for the front end I have fitted a T3 spool and Hudy spring steel 52mm shafts for a stronger replacement of the original alloy 46mm shafts. All is needed is a little shimming of around .5-.75. This is a 38t pulley to work with the gear diff. Just pity there is a little less Purple on the car now
Thanks for the parts Ant
Thanks for the parts Ant
#1499
Tech Addict
iTrader: (9)
In search for shock springs for tight indoor carpet track. I found a setup that runs silver and blue springs. Also the pink linear spring. What is the difference with the regular springs and linear springs. I see setups with blue and pink but it does not say linear.
Last edited by Mugen10; 12-05-2010 at 04:50 PM.
#1500
Hi guys a little more progress on the car. For those of you looking for an alternative for the front end I have fitted a T3 spool and Hudy spring steel 52mm shafts for a stronger replacement of the original alloy 46mm shafts. All is needed is a little shimming of around .5-.75. This is a 38t pulley to work with the gear diff. Just pity there is a little less Purple on the car now
Thanks for the parts Ant
Thanks for the parts Ant